Roland JD-08 Manual
Also See for JD-08:

Advertisement

Roland JD-08 Manual

Panel Descriptions

Top Panel (Control Section)
Top Panel (Control Section)

No. Name Explanation
1 LAYER buttons
([TONE A]–[TONE D] buttons)
The functions of the LAYER buttons change depending on the status of the [LAYER- ACTIVE] button.
LAYER Turns the layer on/off. The LAYER button lights up for layers that produce sound.
ACTIVE Select the layer to edit. The selected LAYER button blinks.
2 [LAYER-ACTIVE] button Toggles between functions of the LAYER button.
Off LAYER
On ACTIVE
3 [ARPEGGIO] button Turns the arpeggio on/off. Long-press the button to show the arpeggio settings menu.
4 [NOTE] button When this is on, you can use the [1]–[13] buttons as a keyboard.
5 [COMMON] button Displays the settings menu.
* Press the [EFFECTS] button while holding down the [COMMON] button to edit the sequencer (STEP SEQ). Press the [COMMON] button again to show the sequencer settings menu.
6 [EFFECTS] button Displays the effects settings menu.
7 [START] button Plays back (the button lights up) or stops the sequencer (the button goes dark). Use this together with the [1]–[16] buttons to switch to different patterns.
8 [EXIT] button Returns to the previous screen.
9 [VALUE] knob Edits the parameter's value. Press the knob to confirm the value or operation.
10 Display Shows the bank and patch number, parameter value and tempo.
11 [1]–[16], [PAGE/TIE] button Use these buttons to switch between tones (patch/bank), and to input notes into the sequencer.
12 Tone section (controls inside the outlined section) Use these controls to edit the tones. Refer to the manual on our website for details.

Rear Panel
Rear Panel

No. Name Explanation
13 [POWER] switch This turns the power on/off.
14 USB Type-C® port Use a commercially available USB Type-C cable to connect this port to your computer. It can be used to transfer USB MIDI and USB audio data. You must install the USB driver when connecting the JD-08 to your computer. Download the USB driver from the Roland website.
https://www.roland.com/global/support/
15 [VOLUME] knob Adjusts the volume.
16 PHONES jack Connect headphones (sold separately) here.
17 OUTPUT jack Connect this jack to your amp or monitor speakers.
18 MIX IN jack This is the audio input jack. Sound from the connected device is output from the PHONES jack and OUTPUT jack.
19 MIDI connectors Connect a MIDI device to these connectors using a commercially available MIDI cable. This lets you control the connected MIDI devices from this unit.

Outputting Sound

  1. Turn the JD-08 power on.
    * Before turning the unit on/off, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound when switching the unit on/off. However, this is normal and does not indicate a malfunction.
  2. Hold down the [START] button and press the [9]– [16] buttons (NUMBER 1–8).
    Select a pattern. The pattern number appears on the display.
  3. Press the [START] button.
    This plays back the pattern. Press the [START] button again to stop the pattern.

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Roland JD-08 Manual

Advertisement

Need help?

Need help?

Do you have a question about the JD-08 and is the answer not in the manual?

Questions and answers

Table of Contents