Table of Contents
Advertisement
enabled. The router sends Request to Send (RTS) frames to a particular receiving station
and negotiates the sending of a data frame. After receiving an RTS, the wireless station
responds with a Clear to Send (CTS) frame to acknowledge the right to begin transmission.
Fill the range from 0 to 2347 into this blank.
3.
Beacon Interval
Beacons are packets sent by an access point to synchronize a wireless network. Specify a
beacon interval value. The allowed setting range is 20-1024 ms.
4.
Preamble Type
The preamble (also called "a header") is a section of data at the head of a packet that
contains information that wireless devices need when they send and receive packets. Short
preambles improve throughput performance, but some wireless devices require long
preambles. Select the suitable preamble as short or long preamble.
5.
IAPP
Inter Access Point Protocol. Allow seamless roaming between Access Points in your
wireless network. Coupled with superior RF performance
6.
Protection
Select to enable the wireless protection or not.
7.
Aggregation
Data aggregation can reduce the amount of data routed through the network, and increasing
throughput.
8.
Short GI
Enabling the Short Guard Interval increases the wireless transmission.
9.
RF Output Power
User can adjust the RF output power to get the best wireless connection. There are 5 power
types available: 100%, 70%, 50%, 35%, and 15%.
10. Apply Changes & Reset
Click on "Apply Changes"to save the setting data. Or you may click on "Reset"to clear all the
input data.
http://www.sapido.com.tw
59
User' s Manual V1.0
Advertisement
Table of Contents
