Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Stairville RevueLED 120 COB True White
Summary of Contents for Stairville RevueLED 120 COB True White
- Page 1 RevueLED 120 COB True White LED Spotlight...
- Page 2 Thomann GmbH Hans-Thomann-Straße 1 96138 Burgebrach Germany Telephone: +49 (0) 9546 9223-0 Internet: www.thomann.de 31.10.2024, ID: 443734 (V3)
-
Page 3: Table Of Contents
7.5 Functions in 2-channel DMX mode (mode 1)................ 34 7.6 Functions in 2-channel DMX mode (mode 2)................ 35 7.7 Functions in 3-channel DMX mode................... 35 7.8 Functions in 4-channel DMX mode................... 36 Technical specifications........................37 Plug and connection assignments....................40 RevueLED 120 COB True White LED Spotlight... - Page 4 Table of contents Troubleshooting............................41 Cleaning............................... 43 Protecting the environment......................44 RevueLED 120 COB True White LED Spotlight...
- Page 5 RevueLED 120 COB True White LED Spotlight...
-
Page 6: General Information
1.1 Symbols and signal words In this section you will find an overview of the meaning of symbols and signal words that are used in this document. RevueLED 120 COB True White LED Spotlight... - Page 7 Warning signs Type of danger Warning – high-voltage. Warning – dangerous optical radiation. Warning – suspended load. RevueLED 120 COB True White LED Spotlight...
- Page 8 General information Warning signs Type of danger Warning – danger zone. RevueLED 120 COB True White LED Spotlight...
-
Page 9: Safety Instructions
Always dispose of packaging material properly when it is not in use. Never allow children to use the device without supervi‐ sion. Keep small parts away from children and make sure that the device does not shed any small parts (such knobs) that children could play with. RevueLED 120 COB True White LED Spotlight... - Page 10 Always secure the barn door with a safety cable on the spotlight. The safety cable must run outside the barn door to not interfere with the light emission. RevueLED 120 COB True White LED Spotlight...
- Page 11 (FI). Ensure that the power cord plug is easily accessible at all times if it is the only device to safely disconnect the device from the mains supply. As a precaution, disconnect the device from the power grid when storms are approaching or it the device will not be used for a longer period. RevueLED 120 COB True White LED Spotlight...
- Page 12 Using fuses of a different type than compatible with the device may cause a fire and seriously damage the device. Only use fuses of the same type. Observe the labelling on the device casing and the information in the "Technical data” chapter. RevueLED 120 COB True White LED Spotlight...
-
Page 13: Features
Features Features As a professional LED spotlight, the RevueLED 120 COB True White is suitable for use on the‐ atre stages, at exhibitions and in media productions. Special features of the device: 120-W COB LED (warm white and cold white) -
Page 14: Installation
Always secure the barn door with a safety cable on the spotlight. The safety cable must run outside the barn door to not interfere with the light emission. RevueLED 120 COB True White LED Spotlight... - Page 15 If the spotlight is operated with the barn doors closed, there is a risk of over‐ heating and fire. In addition, even short-term operation with the barn doors closed can reduce the service life of the LEDs. Operate the device only with open barn doors. RevueLED 120 COB True White LED Spotlight...
- Page 16 If the DMX connections are wired incorrectly, this can cause errors during the data transfer. Do not connect the DMX input and output to audio devices, e.g. mixers or ampli‐ fiers. Use special DMX cables for the wiring instead of normal microphone cables. RevueLED 120 COB True White LED Spotlight...
-
Page 17: Mounting Options
The safety cable must be attached to the safety cable eyelet. Please note that this device must not be connected to a dimmer. RevueLED 120 COB True White LED Spotlight... -
Page 18: Starting Up
Connect the output of the first DMX device to the input of the second one, and so on to form a daisy chain. Always ensure that the output of the last DMX device in the daisy chain is terminated with a resistor (110 Ω, ¼ W). RevueLED 120 COB True White LED Spotlight... - Page 19 Connect the DMX output of the master device to the DMX input of the first slave device. Then connect the DMX output of the first slave device to the DMX input of the second slave device and so on. RevueLED 120 COB True White LED Spotlight...
-
Page 20: Connections And Controls
Connections and controls Connections and controls & DMX INPUT DMX OUTPUT ö POWER OUT POWER IN 100-240V~50/60Hz F2AL250V [[[[ MENU DOWN ENTER True White CW WW RevueLED 120 COB True White LED Spotlight... - Page 21 [DOWN] | Navigates downwards in a menu list. Decreases the displayed value by one. [ENTER] | Confirms a selected value. [F2AL250V] | Fuse holder [POWER OUT] | Lockable output socket (Power Twist) for the power supply for further devices Safety cable eyelet RevueLED 120 COB True White LED Spotlight...
-
Page 22: Operating
ð The respective submenu is displayed or the new value is confirmed. To return to the previous menu level without changes, press [MENU]. Resetting to factory defaults To reset the device to its default settings, press and hold [MENU] for 5 seconds. RevueLED 120 COB True White LED Spotlight... - Page 23 Press [MENU] and press [UP] or [DOWN] repeatedly until the display shows ‘Addr’ . Press [ENTER]. Use [UP] or [DOWN] to select the required DMX address between 001 and 512 (display ‘d.001’ … ‘d.512’ ). Confirm the selection with [ENTER]. ð The selection is applied. RevueLED 120 COB True White LED Spotlight...
- Page 24 Press [ENTER]. Use [UP] or [DOWN] to select the required DMX mode (display ‘1CH’ , ‘2CH1’ , ‘2CH2’ , ‘3CH’ , ‘4CH’ ). Confirm the selection with [ENTER]. ð The selection is applied. RevueLED 120 COB True White LED Spotlight...
- Page 25 Use [UP] or [DOWN] to select the required value for the sensitivity of the built-in micro‐ phone. A value between ‘SEn0’ (low) and ‘SEn9’ (high) can be selected for the sensitivity of the built-in microphone. Confirm the selection with [ENTER]. ð The selection is applied. RevueLED 120 COB True White LED Spotlight...
- Page 26 Use [UP] or [DOWN] to select the required value for the flash frequency. A value between ‘0 Hz’ (low) and ‘30 Hz’ (high) can be selected for the flash rate. Confirm the selection with [ENTER]. ð The selection is applied. RevueLED 120 COB True White LED Spotlight...
- Page 27 Use [UP] or [DOWN] to select the required value for the brightness of the cold white LED. A value between ‘0’ (low) and ‘255’ (high) can be selected for the brightness of the cold white LEDs. Confirm the selection with [ENTER]. ð The selection is applied. RevueLED 120 COB True White LED Spotlight...
- Page 28 Use [UP] or [DOWN] to select ‘HoLd’ if you want the spotlight to maintain the last set effect if the DMX controller fails. Confirm the selection with [ENTER]. ð The selection is applied. RevueLED 120 COB True White LED Spotlight...
- Page 29 0% and 100%. The figure shows a schematic of the adjustable dimmer curves. Linear S-Type Inv Square Square 100 % 100 % 100 % 100 % ö ö ö ö RevueLED 120 COB True White LED Spotlight...
- Page 30 Inverted square curve with a steep course at the begin‐ ning and a flat course at the end ‘LoG’ Square Square curve with a flat course at the beginning and a steep course at the end RevueLED 120 COB True White LED Spotlight...
- Page 31 Press [MENU] and press [UP] or [DOWN] repeatedly until the display shows ‘VEr’ . Confirm the selection with [ENTER]. ð The display shows the software version of the device. Press [MENU] to return to the main menu. RevueLED 120 COB True White LED Spotlight...
- Page 32 Press [MENU] and press [UP] or [DOWN] repeatedly until the display shows ‘tEMP’ . Confirm the selection with [ENTER]. ð The display shows the device temperature. Press [MENU] to return to the main menu. RevueLED 120 COB True White LED Spotlight...
-
Page 33: Menu Overview
Operating 7.3 Menu overview Addr CH-M diSp dMXF SLAV Sond MANu diMC drES diMM d001 BLAC LINE Sen0 2CH1 HoLd LAMP d512 Sen9 2CH2 FLAS 0 Hz 30 Hz tEMP rSEt RevueLED 120 COB True White LED Spotlight... -
Page 34: Functions In 1-Channel Dmx Mode
7.5 Functions in 2-channel DMX mode (mode 1) Channel Value Function 0…255 Brightness of dimmer (0% to 100%) 0…5 The colour temperature setting follows the dimmer control 6…255 Colour temperature 2800 K to 7800 K RevueLED 120 COB True White LED Spotlight... -
Page 35: Functions In 2-Channel Dmx Mode (Mode 2)
Brightness of dimmer (0% to 100%) 0…5 Strobe on 6…255 Strobe speed from slow to fast (1 Hz to 30 Hz) 0…5 The colour temperature setting follows the dimmer control 6…255 Colour temperature 2800 K to 7800 K RevueLED 120 COB True White LED Spotlight... -
Page 36: Functions In 4-Channel Dmx Mode
Brightness of dimmer (0% to 100%) 0…5 Strobe on 6…255 Strobe speed from slow to fast (1 Hz to 30 Hz) 0…255 Warm white intensity (0% to 100%) 0…255 Cold white intensity (0% to 100%) RevueLED 120 COB True White LED Spotlight... -
Page 37: Technical Specifications
Technical specifications Technical specifications 248 mm DMX INPUT DMX OUTPUT POWER OUT POWER IN 100-240V~50/60Hz F2AL250V [[[[ MENU DOWN ENTER True White CW WW 263 mm 305 mm 265 mm 344 mm RevueLED 120 COB True White LED Spotlight... - Page 38 1 × XLR panel socket, 3-pin Power consumption 120 W Supply voltage 100 - 240 V 50/60 Hz Fuse 5 mm × 20 mm, 2 A, 250 V, fast blow International Protection Rating IP20 Mounting options Hanging, standing RevueLED 120 COB True White LED Spotlight...
-
Page 39: Further Information
5.5 kg Ambient conditions Temperature range 0 °C…40 °C Relative humidity 20%…80% (non-condensing) Further information Design Cannon Floor housing Fanless Remote control Not possible Wireless DMX Suitable for outdoor use Housing colour Black RevueLED 120 COB True White LED Spotlight... -
Page 40: Plug And Connection Assignments
The unit offers a 3-pin XLR socket for DMX output and a 3-pin XLR plug for DMX input. Please refer to the drawing and table below for the pin assignment of a suitable XLR plug. Configuration Ground, shielding Signal inverted (DMX–, ‘cold signal’) Signal (DMX+, ‘hot signal’) RevueLED 120 COB True White LED Spotlight... -
Page 41: Troubleshooting
Use special DMX cables for the wiring instead of normal microphone cables. In the following we list a few common problems that may occur during operation. We give you some suggestions for easy troubleshooting: RevueLED 120 COB True White LED Spotlight... - Page 42 DMX mode on another device. If the procedures recommended above do not succeed, please contact our Service Center. You can find the contact information at www.thomann.de. RevueLED 120 COB True White LED Spotlight...
- Page 43 The fan grids of the device must be cleaned of any contamination, such as dust, etc. on a reg‐ ular basis. Before cleaning, switch off the device and disconnect mains-operated devices from the mains. Only use pH-neutral, solvent-free and non-abrasive cleaning agents. Clean the unit with a slightly damp lint-free cloth. RevueLED 120 COB True White LED Spotlight...
-
Page 44: Protecting The Environment
Do not dispose of these materials with your normal household waste, but make sure that they are collected for recycling. Please follow the instructions and markings on the packaging. Observe the disposal note regarding documentation in France. RevueLED 120 COB True White LED Spotlight... - Page 45 Also note that waste avoidance is a valuable contribution to environmental protection. Repairing a device or passing it on to another user is an ecologically valuable alternative to disposal. If your old device contains personal data, delete those data before disposing of it. RevueLED 120 COB True White LED Spotlight...
- Page 46 Notes RevueLED 120 COB True White LED Spotlight...
- Page 48 Musikhaus Thomann · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de...
Need help?
Do you have a question about the RevueLED 120 COB True White and is the answer not in the manual?
Questions and answers