Samsung CLX-3170FN User Manual page 77

MESSAGE MEANING
Memory Full The memory is full.
Network Error There is a problem
with the network.
[No Answer] The receiving fax
machine has not
answered after
several redial
attempts.
NonSAMSUNG The toner cartridge
which the arrow
Toner
indicates is not a
Samsung-genuine
cartridge.
Press OK to toggle
the message to Stop
or Continue.
Stop
Not Assigned The speed button or
speed dial number
you tried to use has
no number assigned
to it.
One Page is Single page data
exceeds the
Too Large
configured mail size.
Open Heat Error There is a problem in
the fuser unit.
Cycle Power
Operation You are in the Add
Page/Cancel Job
Not Assigned
operation, but there
are no jobs stored.
Out-Bin Full The output tray of the
machine is full of
paper.
Over Heat Error There is a problem in
the fuser unit.
Cycle Power
SUGGESTED
SOLUTIONS
Delete unnecessary fax
jobs and retransmit after
more memory becomes
available. Alternatively,
split the transmission
into more than one
operation.
Contact your network
administrator.
Try again. Make sure
that the receiving
machine is operational.
You can select either
Stop or Continue with
the left/right arrow.
If you select Stop by
pressing OK on the
control panel, the
machine stops printing.
If you select Continue,
the machine keeps
printing, but the quality
cannot be guaranteed.
If you do not select any,
the machine will work as
Stop is selected.
Replace the
corresponding toner
cartridge with a
Samsung-genuine
cartridge. (See
"Replacing the toner
cartridge" on page 67.)
Enter the number
manually using the
number keypad or store
the number or address.
Reduce the resolution
and try again.
Turn the power switch
off and on. If the problem
persists, call for service.
Check the display to see
if there are any
scheduled jobs.
Remove paper.
Turn the power switch
off and on. If the problem
persists, call for service.
MESSAGE MEANING
Paper Jam 0 Paper has jammed in
the feeding area of the
Open/Close Door
tray.
Paper Jam 1 Paper has jammed in
the paper exit area.
Check Inside
Paper Jam 2 Paper has jammed In
the fuser area or
Check Inside
around the toner
cartridge
Refilled Toner The toner cartridge
you have installed is
not genuine or refilled.
The arrow indicates
which color toner
cartridge.
Replace Toner This message
appears between
Toner Empty and
Toner Low status.
Replace The life of the part
expires totally.
[xxx]
Replace The life of the part
expires soon.
[xxx] Soon
Replace/Install The life span of the
waste toner tank has
Toner Waste Bin
expired and the printer
will stop printing until
a new waste toner
tank is placed into the
machine.
Retry Redial? The machine is
waiting for a specified
time interval to redial
a previously busy
station.
Scan Unit Open The scan unit is not
securely latched.
Scanner locked The scanner module
is locked
Send Error There is a problem in
SMTP authentication.
(AUTH)
Send Error There is a problem in
DNS.
(DNS)
SUGGESTED
SOLUTIONS
Clear the jam. (See "In
the tray 1" on page 73.)
Clear the jam. (See "In
the fuser unit area" on
page 73.)
Clear the jam. (See "In
the paper exit area" on
page 74.)
The print quality may get
poor if the refilled toner
cartridge is installed,
since its characteristics
may significantly differ
from the genuine. We
recommend Samsung-
genuine color toner
cartridge.
Replace the toner
cartridge with a new one.
(See "Replacing the
toner cartridge" on
page 67.)
Replace the part with a
new one. Call for
service.
See "Checking
replaceables" on
page 71 and call for
service.
Replace the waste toner
bank with a new one.
(See "Replacing the
waste toner
container" on page 70.)
You can press OK to
immediately redial, or
Stop/Clear to cancel the
redial operation.
Close the scan unit it
locks into place.
Turn the power switch
off and on. If the problem
persists, call for service.
Configure the
authentication setting.
Configure the DNS
setting.
Troubleshooting_ 77