Charge Rate - AT&T Bell System Plant Series Installation Manual

SECTION 506-101 ·201
s.
SETTING TOTALIZER CHARGE RATE
6.01
The totalizer, mounte d on the s ide of co in
chute. steps orne i ncrement
ro.r
e ach 5 Cf.;!nt s
deposite d. A nickel equals one, dime equa ls two,
and a quane r equals five increments .
Use
extreme care wlren
se tting
total·
izer.
Auoid damaging pawl and
spring
pile-ups. (See f ig. 8.)
6.02 Two
paper clips,
or equivalent, are used to
set the totalizer.
6.03 To set totalizer:
(1)
Rotate shaft In the proper direction (from
bottom
to
top) until s prings T 2 rest in de-
pression on shaft (l'lg. 8).
SPR I NG PILE· UPS
Tl
c
(2) Release plastic latch reset (Fig. 9) and
check s prings Tl.
(a)
If
springs Tl are not operated. pro-
<.:t!ed wJth [he normal sequence of
instructions.
(b) If
springs
Tl
are found to
be
operated.
omlt insuuction 3; to How instructions
4, 5, a.nd 6; omit Instruction 7, and then
proceed in the normal sequence of in-
Slr.uc ttons.
(3)
Rotate s haft in p ro per direction until
springs T l op erate as lndlcated by
a
movcm~nt
of tbc
p
1 a a t 1 c latch reset
(Fig. 9).
(4) Do nor al low rhe shaft to move. lnserc one
ol the p.aper c lips into bole located near
the
onset on r ight end of shaft. (See
rig. 9.)
SHAFT DEPRESSION
Fig. 8. Totalizer Spring Pile·ups
•