Delta In2ition 58467-SS Manual

Parts Included

Cleaning of Parts
Only clean with a mild non-abrasive detergent and soft cloth.
Note: Any other cleaning product not specifically designed for cleaning plastic or metal surfaces may damage the finish.

Installation

1. Install the Shower Head
   
   1. Turn off water supply before installing the Shower Head.
   2. Remove existing Shower Head from Shower Arm.
   3. Apply plumber tape (not included) to Shower Arm, if necessary, to stop or prevent leaks.
   4. Hand tighten the Ball Connector of the Shower Head to the Shower Arm.
2. Install Hand Shower
   
   1. Place the hose washers into the hose nuts on each end of the hose.
   2. Attach the end of the hose with a hex nut to the shower head. Connect the other end of the Metal Hose to the Hand Shower. All connections should be able to be made by hand tightening only.
   3. To change spray modes, turn the lever (located on the front of the Hand Shower) left or right to the desired setting.

   Changing Modes From Shower Head, to Hand Shower, or to Both
   

   1. Turn knob on side of Shower Head to change between:
   • Shower Head only
   • Shower Head and Hand Shower
   • Hand Shower only
3. Insert Hand Shower into Shower Head
   1. Slide Hand Shower into the top of the Shower Head.
      
   2. Gently push the Hand Shower down into the Shower Head.
      
   • If the Shower Head moves when inserting or removing the Hand Shower, hand tighten the connection between the Shower Head and the Ball Connector.
4. Removing the Hand Shower from the Shower Head
   1. Push the lower part of the Hand Shower upwards, away from the Shower Head.
      
   2. Pull the Hand Shower away from the slot in the Shower Head.