Chapter 8: Installation
NMEA OUT connector
Pin 2, white
Pin 5, screen
Rear of display
Figure 8-15: NMEA Output Connector
Data Conversion
The displays convert some information across the communications links as
follows:
NMEA In to NMEA Out and SeaTalk
SeaTalk to NMEA Out
This enables data received by the display to be passed to other instruments.
You can prevent NMEA heading data being bridged onto the Seatalk bus -
refer to Bridge NMEA Heading on page 7-8.
Note: To transfer NMEA data, or to convert the data, the display must be pow-
ered On.
Pin 3, blue
Pin 4, not connected
3
2
NMEA out
4
5
NMEA OUT connector
Pin
Pin name
Function
2
NMEA_GND
NMEA ground
3
NMEA_SIG
NMEA data output
4
N/C
N/C
5
CGND
Screen
*Pin 1 does not exist on this connector
8-27
D4254_1