Inter-Unit Scanner Cable - Raymarine SL70RC PLUS Series User Manual

Chapter 8: Installation 8-9
power cable. For further details on the master display power cable length refer
to the Pathfinder Plus Radar Scanner Owner's Handbook.
If a longer power cable run is required, use the supplied power cable to connect
to the display unit. Then use a suitable connector block to connect the free end
to the extension cable, taking particular care to ensure correct polarity. The
supplied power cable has a cross-section of 2.0 mm .
2

Inter-Unit Scanner Cable

The inter-unit (scanner) cable entrance is at the rear of the scanner unit. If the
unit is mounted on a hollow mast the cable may be run inside the mast and then
fed through the radar's cable entrance. Make sure that the cable does not chafe
where it enters the mast.
Note: Route the cable from the display up to the scanner, since this will re-
quire the smallest clearance hole.
The type of inter-unit cable, for connecting the scanner to the display unit,
depends on your scanner package. Refer to the Pathfinder Plus Radar
Scanner Owner's Handbook for details, which include length considerations
and bending radii.