Vestergaard LifeStraw - Filter System Manual

Also See for LifeStraw:

User manual (80 pages)

Manual (44 pages)

Quick start manual (2 pages)

Table of Contents

Contents

1 WHAT'S IN THE BOX
2 PRODUCT SETUP
3 CLEANING
4 STORAGE
5 FILTER REPLACEMENT
6 Documents / Resources
- 6.1 References
- 6.2 Download manual

Vestergaard LifeStraw - Filter System Manual

WHAT'S IN THE BOX

PRODUCT SETUP

Rinse Carbon Filter
Unwrap the carbon filter attached to this card. Rinse under cold, running tap water for 1 minute.
Clean filter housing and dispenser
Remove filter housing and rinse with water only. Hand wash the dispenser body with a mild detergent and rinse.
Rinse Membrane Micro filter
Put the filter housing back into the dispenser. Run one batch of water through the filter. Discard water.
Install Carbon Filter
Remove filter housing, pat dry. Pull down and twist the bottom cap of the lter housing to remove. Install carbon filter into housing cap. Press cap back onto housing.
Final Rinse
Put the lter housing back into the dispenser, ensuring spouts align. Run one batch of water through the filter. Discard water.

NOTE: Flow rate may be slow for first few batches as air is displaced from the filters. Flow rate should improve with use.

Ready to use! Enjoy fresh, filtered water.

For filter replacements & accessories visit www.lifestraw.com

CLEANING

Dispenser body
Hand wash with soap or mild detergent.

Filter Housing
Rinse with water only or remove filters before rinsing with soap or detergent.

Membrane Microfilter
Wash with water and small amount of bleach (1/2 tsp mixed with 2C of water). Do NOT wash with soap.

Carbon filter
Rinse with water only.

STORAGE

Daily Use
Store in refrigerator or on countertop.

Long-Term Storage
For non-use longer than 2 weeks: discard remaining water. Remove filters from unit and store in a sealed bag. With next use, clean filters, dispenser body and filter housing per cleaning instructions.
Re-install filters and resume use.