Vestergaard LifeStraw PEAK Series Instructions

Hide thumbs Also See for LifeStraw PEAK Series:

DAILY USE AND CLEANING INSTRUCTIONS FOR LIFESTRAW PEAK SERIES WATER FILTER

STRAW

DAILY USE

Follow these steps for using your Peak Series Water Filter Straw.

1. Sip. Open the top cap and take 5 quick, strong sips to get water flowing.

2. Backwash. Regularly blow air through your filter after drinking to keep the filter clean and prevent it

from clogging. Close both caps when not in use.

3. If using with a standard water bottle, unscrew the bottom cap of the straw, fill the water bottle with

source water, and screw the bottom of the straw to the water bottle. Squeeze water through the straw.

4. If using with a gravity system, attach the hose to the bottom of the straw filter, open the cap and

allow water to flow out of the mouthpiece.

Follow these steps if you have already used your LifeStraw Peak Series filter and you plan to store for

less than 1 month before your next adventure! If you haven't already, make sure to backwash your filter

by blowing air through the mouthpiece and clearing the inside of excess debris.

We recommend rinsing both the bottom and top caps of your straw filter before putting away for

For optimal disinfection (we always recommend when storing for greater than 3 months), follow the

instructions below:

Mix 1/4 teaspoon household bleach solution with 1-2 cups of water. Dip the filter into the bleach

solution far enough so that the end is submerged in solution, and blow into your filter to push and pull

the solution from the filter several times. Rinse with tap water.

Table of Contents

Do you have a question about the LifeStraw PEAK Series and is the answer not in the manual?

Page 1 REGULAR CLEANING AND STORAGE Follow these steps if you have already used your LifeStraw Peak Series filter and you plan to store for less than 1 month before your next adventure! If you haven’t already, make sure to backwash your filter by blowing air through the mouthpiece and clearing the inside of excess debris.
Page 2 STORAGE If storing your product for less than 1 month, place your cleaned filter in a cool, dry place until next use. For long term storage, we recommend storing the filter with a saline solution because it helps prevent any mold or algae from growing while also keeping the membrane microfilter wet which ensures good flow rate when resuming use.