Netio PowerPDU 4PS Quick Installation Manual page 4

RJ45 – green
RJ45 – yellow
M2M (red) LED
Switching all outputs
Restoring factory
defaults
Before the first use
1) Connect your NETIO device to a LAN with a network cable (RJ45).
2) Connect the NETIO device to a mains electrical outlet with the power cable.
3) Switch the device on with the rocker switch on the back or on the side.Wait
about 1 minute until the device starts and receive IP address from DHCP
server.
NETIO Discover
1) Find the NETIO Discover (MS Windows) utility at our website and install it.
2) NETIO Discover finds all NETIO devices on the network and displays them.
Click on the IP address to open the web interface.
3) The displayed MAC address can be checked with the label on the device.
Network Link (lit) + Activity (flashes)
1x flash when the device starts
3x flash when the internal system restarts
Flashing (2 sec lit, 1 sec dark) when the Eth cable is
disconnected and the device is running.
Blink when some M2M communication is in progress
Output test: Press the TGL button 3x rapidly.
– If an output is On (1), all outputs are switched off.
– If all outputs are Off (0), they are all switched On (1).
When powering on the device, hold the "RESET" button
pressed for about 10 seconds, until the yellow LED on the
RJ45 jack flashes 3 times.
4