Saving The Settings (Memory) - Pentax Optio I-10 Operating Manual

Saving the Settings (Memory)

The Memory function is for saving the current camera settings when the
camera is turned off.
For some camera settings, the Memory function is always set to O (On)
(the settings are saved when the camera is turned off), while for others
you can choose on or off (to choose whether the settings are saved or
not when the camera is turned off). The items which can be set to O (On)
or P (Off) in the Memory function are shown in the table below. (Items
not listed here are always saved in the selected settings when the
3
camera is turned off.)
If you select O (On), the settings will be saved in the status they were in
immediately before the camera was turned off. If you select P (Off), the
settings will be reset to the defaults when the camera is turned off. The
table below also shows whether the Memory default setting for each item
is on or off.
Item
Face
Detection
Flash Mode
Drive Mode
Focus Mode
Zoom Position The zoom position set with the zoom lever
MF Position
White Balance
Sensitivity
EV
Compensation
AE Metering
Digital Zoom
DISPLAY
128
A Face Detection mode set by using the I button
The flash mode set with the four-way controller (4)
The drive mode set with the four-way controller (2)
The focus mode set with the four-way controller (5)
The manual focus position set with the four-way
controller (23)
The [White Balance] setting on the [A Rec. Mode]
menu
The [Sensitivity] setting on the [A Rec. Mode] menu
The [EV Compensation] setting on the
[A Rec. Mode] menu
The [AE Metering] setting on the [A Rec. Mode]
menu
The [Digital Zoom] setting on the [A Rec. Mode]
menu
The information display mode set with the
4/W button
Description
Default
Page
Setting
p.70
P
p.100
O
p.90
P
p.91
p.102
P
p.76
P
p.103
P
p.110
P
p.114
P
p.108
P
p.112
P
p.77
O
p.20
P