Table of Contents
Advertisement
5-10: Selecting the Original
Orientation (Original Orientation)
the details.
To stop the copy job, press Stop on
the control panel or touch Stop
4-11:
displayed on the screen. See
Stopping a Copy Job
for details.
You cannot press the Start button if
a message requesting you to
replace the staple cartridge is
displayed. In this case, replenish the
staple cartridge. See
8-6: Replacing
the Staple Cartridge
for details.
If Stapling feature is off in Step 3,
then the copies will be delivered to
finisher Tray 1.
Some features cannot be selected
together with this feature. See
Appendix B: Possible Combinations
of Features
for details.
Do not remove any paper from
finisher Tray 2 while copying is in
progress.
Copying stops when finisher Tray 2
becomes full with 100 sets or 1500
sheets (750 sheets for sizes larger
than A4). Remove the copies from
finisher Tray 2, then press Start to
resume copying.
Select the corresponding document orientation of the original
loaded, and select Save.
Select Head to Top or Head to Left.
for
Confirm the settings at the lower left side of the screen and
select Save.
Select other features if necessary.
Enter the required number of sets by using the keypad and
press Start.
The copies are collated set by set, stapled, and delivered to finisher Tray 2.
You can remove the copies from finisher Tray 2 after all the
copies are delivered and the machine stops.
Basic Features
4
69
4-8 Stapling (Stapling)
Advertisement
Table of Contents
