Erasing The Edges And Copying All (Edge Erase/Copy All); Erasing The Edges And Copying All; (Edge Erase/Copy All) - Panasonic WORKIO DP-6000 Operating Instructions Manual

Added Features
When Copy All is selected,
depending on the type of document
used, the edges of the copies made
may contain marks or image loss
may result.
The Edge Erase default value can
be changed by using the Tools
Mode. The factory default is Normal
(T&B, L&R: 2 mm and
Center: 0 mm)
No copying can be done onto the 2
mm border area of the paper.
If you have selected Reduce/
Enlarge, the area for edge erase will
5
also be reduced/enlarged.
If you have selected Book Copying,
Edge Erase will be based on the
entire image of the document.
If you have also selected Multi-Up
(N Up) and Center (Centre) Erase,
then Edge Erase will be based on
the individual original image.
96

5-8 Erasing the Edges and Copying All (Edge Erase/Copy All)

Erasing the Edges and
Copying All
When copying with the document cover open or when copying bound
documents, shadows are sometimes found at the edges or center of the
copies made. These shadows can be erased with the feature, Edge Erase.
It is also possible to make a copy without erasing these shadows by
selecting Copy All.
Erasing the shadows of documents (Edge Erase)
Set the amount of erase of shadows on the top, bottom, left, or right,
center of the document. The part which Edge Erase is set will not be
copied (that is, will be erased).
Copying onto whole area of paper (Copy All)
Amount of erase is 0 mm, and the entire page is copied.

(Edge Erase/Copy All)