Copying; Copying (Vhs  Dvd) - Panasonic Diga DMR-EZ37 Operating Instructions Manual

Copying

Copying (VHS 
Programs are automatically copied onto the disc from the location of
playback at the time when the copying of the tape starts.
[VHS]  [RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]
Preparation:
 Turn on the television and select the appropriate video input to suit the
connections to this unit.
 [RAM] If the disc is protected, release protection ( 36).
 Insert a disc with enough space for recording.
 Select the DVD recording mode ( 14).
 Insert the VHS tape containing the program to be copied. Stop the tape
at the point where you want to start copying from.
On the main unit
While both DVD and VHS are stopped
COPYING COPYING
[-R] [-R]DL] [-RW‹V›] [+R] [+R]DL]
REC
− or −
PLAY
− Check if copying starts properly ("COPY" is displayed on this unit's display).
− Copying is automatically completed when the tape reaches its end or the
disc becomes full.
Tips
 Additional navigation
You can begin the same kind of copy by using Copy Navigator. Use the operations listed
below instead of step 1 shown above.
1. Press [FUNCTIONS].
2. Press [, ] to select "Copy" then press [ENTER].
Copy Navigator screen appears.
3. Press [, ] to select "VHS to DVD" then press [ENTER].
 Dividing a recording to be copied
When copying from VHS to DVD, recordings on the DVD are divided according to index
signals detected on the tape.
− Recordings within 15 minutes (25 minutes in VP mode) of each other may not be divided properly.
− The time it takes to record may become longer than the original recording depending on the
number of index signals.
 To cancel copying in the middle
Press [ STOP].
− You can also press and hold [RETURN] for about 3 or more seconds to cancel copying in the middle.
However, you cannot stop fi nalizing after it has started.
 When copying multi lingual broadcast program
[-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]
Before starting copy, try playing the VHS and pressing [AUDIO], and then select audio track
that you want to copy. Audio can also be switched during copy.
10
RQT8849
DVD)
Press and hold for about
3 seconds.
to copy and automatically fi nalize
when done
(see page 38 for more information on fi nalizing)
− If you press [ STOP], you can cancel copying.
to copy without fi nalizing.
− If you press [ STOP], you can cancel copying.
SKIP/INDEX
STOP PAUSE
TIME SLIP / JET REW
ENTER
SUB MENU
AUDIO DISPLAY
REC REC MODE
.
Notes
 If copying doesn't complete due to
shortage of remaining time, disc
space, or other reasons, fi nalizing
won't start.
 When copying doesn't start, the
"COPYING" indicator on the main unit
blinks for about 7 seconds. Check if
the unit is properly prepared.
 If a part of a tape recorded in VP
mode is copied to disc, noise may
appear at the beginning of the copied
part.
COPYING COPYING
COPYING indicator
REW FF
PLAY
CM SKIP
RETURN
CREATE
VCR/TV
CHAPTER
F Rec STATUS