Connecting Peripherals - Panasonic Toughbook CF-19PJRFXAM Reference Manual

Troubleshooting (Advanced)
Wireless Communication (only for model with wireless LAN/Bluetooth/wireless
WAN)
Cannot connect to a network.
Access point is not detected.

Connecting Peripherals

An error occurs while installing the
driver.
Slide the wireless switch to turn on the wireless devices.
Set the devices ([Wireless LAN] / [Bluetooth] / [Wireless WAN]) to [Enabled] in
the [Advanced] menu of the Setup Utility (
Disable the Wireless Connection Disable Utility (
Restart the computer.
You cannot turn on wireless LAN if you uninstalled Display Rotation Tool.
To reinstall it, click
Search], and press Enter.
Shorten the distance between the computer and the access point, and try the
detection again.
Confirm the following settings:
• [Wireless LAN] in the [Advanced] menu of the Setup Utility
Confirm that [Wireless LAN] is set to [Enabled] (
• Wireless Switch
Slide the wireless switch to ON.
• Wireless Switch
Utility Confirm that Wireless LAN is ON (
This computer uses channels 1 through 11
Check the channel being used by the access point.
*1
In the case of wireless communications, the frequency band being used can be divided
into segments, so that different communications can be conducted on each band
segment. A "Channel" refers to the individual frequency bandwidth divisions.
When you install a driver of card or peripheral device, make sure that the driver
is compatible with the operating system. If it is not compatible, malfunction may
occur. For information about the driver, contact the manufacturer of the
peripheral device.
page
(Start) and input [c:\util\disprot\Setup.exe] in [Start
page
*1
when using IEEE802.11b/g.
117
97).
page 82).
page 97).
80).