Example Of Connecting To Computer - Panasonic PT-L520U Operating Instructions Manual

Example of connecting with video equipments
D-sub 15 (male) - BNC5 (female)
Computer for
adapter cable (sold separately)
control use
Red (connect to P
Blue (connect to P
Green (connect to Y signal connector)
D-sub 9-pin
(male)
Audio system
NOTE:
B Only one audio system circuit is available for the AUDIO IN L-R jacks for
S-VIDEO/VIDEO signals, so if you wish to change the audio input source,
you will need to remove and insert the appropriate plugs.
B Only one audio system circuit is available for the RGB AUDIO IN jacks, so
if you wish to change the audio input source, you will need to remove and
insert the appropriate plugs.
B If an audio system is connected to the AUDIO OUT jack, the sound
volume balance can be controlled by the remote control unit which is
supplied with the projector.
B If the video signal source is connected using a cable with a BNC
connector plug, use a BNC/RCA adapter (sold separately) to convert the
cable end to an RCA plug-type jack.
B Refer to page 56 for a list of compatible YP
to the projector.
B If the signal cables are disconnected or if the power supply for the
computer or video deck is turned off while the digital zoom or index
window functions are being used, these functions will be cancelled.
22
signal connector)
R
signal connector)
B
Digital broadcast
tuner or DVD player
DVD player Video deck
P signals which can be input
B R

Example of connecting to computer

Monitor
Computer for
control use
D-sub 9-pin
(male)
NOTE:
B It is better to shut down the computer before turning off the MAIN POWER
switch of the projector.
B Refer to the list of compatible signals on page 56 for the types of RGB
signals which can be input to the projector by connecting a computer.
B Do not input the signal to the RGB2 IN/RGB1 OUT connector when the
RGB2 SELECT item in the OPTION1 menu is set to OUTPUT. (Refer to
page 40.)
Computer
ON DIP
1 3 2 5 4 6
Audio system
23