Fcc Information - Panasonic KX-T7737 Quick Reference Manual

NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC Part 68 Approved Device:
This equipment is approved under FCC Part 68 as a component device for use with a
Panasonic KX-TA624/KX-TA824/KX-TAW848/KX-TDA series PBX. In order for
approval of this product to be valid, all other products used in conjunction with this
product must also be FCC Part 68 approved as a component device for use with the
PBXs listed above. If any of these components are not approved, then you, as owner
or user, are required to obtain FCC Part 68 approval of the assembled equipment prior
to connection to the telephone network. Part 68 approval requires that you maintain
this approval over time and as such you are responsible for the following:
– Any component added to your equipment, whether it bears component approval or
not, will require a Part 68 compliance evaluation. You may need to test, reapprove,
and make a filing to the ACTA database before that new component can be used;
– Any modification/update made to any approved component within your equipment
will require a Part 68 compliance evaluation. The modifying entity becomes the
Responsible Party for the modified equipment. The Responsible Party will need to
determine if a new test, approval, and filing to the ACTA database is required before
that modified component can be connected to the network;
– If the Responsible Party continues to produce this component that party is required
to comply with all continuing compliance requirements under FCC rules.

FCC Information

21