Message Display - Panasonic Lumix DMC-FX100 Operating Instructions Manual

Others
∫ About tripods
• When you use a tripod, make sure the
tripod is stable when this unit is attached
to it.
• You may not be able to remove the card or
the battery when using a tripod.
• Make sure that the screw on the tripod is
not at an angle when attaching or
detaching the camera. You may damage
the screw on the camera if you use
excessive force when turning it. Also, the
camera body and the rating label may be
damaged or scratched if the camera is
attached too tightly to the tripod.
• Read the operating instructions for the
tripod carefully.

Message Display

Confirmation messages or error messages
will be displayed on the screen in some
cases.
The major messages are described below
as examples.
[THIS MEMORY CARD IS LOCKED]
The Write-Protect switch on the SD
Memory Card and the SDHC Memory Card
are moved to [LOCK]. Move the switch
back to unlock it. (P14, 86, 91)
[NO VALID PICTURE TO PLAY]
Record a picture or insert a card with a
recorded picture and then play it.
[THIS PICTURE IS PROTECTED]
Delete or overwrite the picture after
canceling the protect setting. (P86)
[THIS PICTURE CANNOT BE DELETED]/
[SOME PICTURES CANNOT BE
DELETED]
Pictures not based on the DCF standard
cannot be deleted. If you want to delete
some pictures, format the card after saving
necessary data on a PC etc. (P91)
[NO ADDITIONAL DELETE SELECTIONS
CAN BE MADE]
104
VQT1F52
You have exceeded the number of pictures
that can be set at one time with [MULTI] in
[DATE STAMP] or [MULTI DELETE].
Delete the set pictures or stamp the date
information on them and then do the
operation for any remaining pictures.
More than 999 favorites have been set.
[CANNOT BE SET ON THIS PICTURE]
DPOF print cannot be set for pictures not
based on the DCF standard.
[NOT ENOUGH SPACE ON BUILT-IN
MEMORY]/[NOT ENOUGH MEMORY ON
THE CARD]
There is no space left on the built-in
memory or the card.
• When you copy pictures from the built-in
memory to the card (batch copy), the
pictures are copied until the capacity of
the card becomes full.
[SOME PICTURES CANNOT BE
COPIED]/[COPY COULD NOT BE
COMPLETED]
The following pictures cannot be copied.
• When a picture with the same name as
the picture to be copied exists in the copy
destination.
(Only when copying from a card to the
built-in memory.)
• Files not based on the DCF standard.
Moreover, pictures recorded or edited by
other equipment may not be copied.
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
This message will be displayed when you
formatted the built-in memory on a PC.
Format the built-in memory on the camera
again. (P91) The data on the built-in
memory will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The card format cannot be recognized by
the camera. Format the card again with the
camera after saving necessary data on a
PC etc. (P91)