Using The Lcd; Emphasizing Outlines - Panasonic AG-HMC40 Operating Instructions Manual

Viewfinder (continued)

Using the LCD

1
Set the POWER switch to ON. (Page 26)
2
Open the LCD monitor.
The monitor opens up to 90°. Attempting to
open it further with force may damage the
camera.
90°
3
Adjust the angle of the LCD monitor to a
convenient viewing position.
• The monitor can be rotated 180° toward the
lens and 90° toward the eye piece.
• Attempting to rotate it further with force
or closing it in a 90° position may damage
the camera.
180°
• When closing the LCD monitor, be sure to
close it fully.
• When the LCD monitor is facing the lens
(during self-portrait recording), both the
viewfinder and the LCD monitor will be lit.
30

Emphasizing outlines

When EVF DTL is assigned to one of the USER
buttons 1 to 3, you can press that button to
emphasize the outlines of images in the viewfinder
or LCD monitor, and make focus alignment easier.
Emphasizing the outlines does not effect the
images you shoot.
1
Touch USER1 SW, USER2 SW, or USER3
SW in the setting menu SW&DISP SETUP
screen.
2
Touch EVF DTL.
EVF DTL is assigned to the selected USER
button.
3
In CAMERA mode or PHOTO mode, press
the USER button assigned to EVF DTL.
"EVF DTL ON" appears in the center of the
screen for about  seconds.
To release the setting, press the USER button
assigned to EVF DTL again, and "EVF DTL
OFF" appears in the center of the screen for
approximately  seconds.
90°