Error Displays - Panasonic AG-HMC40 Operating Instructions Manual

Screen displays (continued)
■
R
REC STOPPED.
NOW WRITING.
Video recording has been stopped. Data is now
being written to the card.
REPAIR CLIP?
Do you wish to repair clips now?
■
S
SET DATE AND TIME
Set the date and time.
■
T
THE CLIP ARE PROTECTED.
PLEASE REMOVE THE PROTECTION.
The clip is protected. Please cancel the
protection.
THE RECORDING IS STOPPED
(OVER THE LIMITATION)
Recording will stop. (Continuous recording for 1
hours)
THE TC MODE IS CHANGED
TO "NDF"
NDF is selected as the TC MODE setting.
THIS BATTERY CANNOT
BE USED.
This battery cannot be used.
THIS CARD CANNOT
RECORD IN VIDEO MODE.
The card cannot be used for video recording.
THUMBNAIL DATA ERROR
IS DETECTED.
An error has been detected in the thumbnail
information.
9
■
U
UNABLE TO FORMAT.
The card cannot be formatted.

Error displays

The following messages are displayed when
an error has occurred in the camera or the SD
Memory Card. If the problem is not solved by
switching the power off and back on again,
either change the card in accordance with the
instructions displayed, or consult the place of
purchase.
■
E
ERROR OCCURRED.
RECORDING IS STOPPED.
Displayed when an error has occurred during
recording. Start the recording again. If the
message appears again, please consult the
place of purchase.
• Please switch the power off if the message
continues to appear.
• Please try inserting a different card if the
message appears again after restarting
recording.
■
P
POWER TURNED OFF DUE TO FAN
STOPPING.
Displayed when an error has occurred with the
fan. The power then turns off.
Wait a few minutes, and then try turning the
power on again.
■
S
SYSTEM ERROR
TURN POWER OFF
Displayed when an error has occurred in the
system. Switch the power off and back on again.
• If this error is displayed when accessing the
SD Memory Card, such as when deleting a
clip, the SD Memory Card may be damaged.
Please replace it with a new SD Memory
Card.
• If this error is displayed when repairing the
SD Memory Card, please use the AVCCAM
Restorer content repair software (Page 37).