Olympus Stylus 730 Advanced Manual page 60

Monitor indication
q
WRITE-PROTECT
>
MEMORY FULL
q
CARD FULL
L
NO PICTURE
r
PICTURE ERROR
r
THE IMAGE
CANNOT BE
EDITED
CARD-COVER
OPEN
g
BATTERY EMPTY
C A R D S ETUP
POWER OFF
FORMAT
SET OK
M E MORY SETUP [ I N ]
POWER OFF
MEMORY FORMAT
SET
OK
NO CONNECTION
NO PAPER
NO INK
JAMMED
60
EN
Possible cause
Writing to the card is
prohibited.
The internal memory has no
available memory and
cannot store any new data.
The card has no available
memory and cannot store
any new data.
There are no pictures in the
internal memory or on the
card.
There is a problem with the
selected picture and it
cannot be played back on
this camera.
Pictures taken by other
cameras, or previously
edited or corrected pictures
cannot be edited or fixed.
The battery compartment/
card cover is open.
The battery is empty.
This card cannot be used in
this camera, or the card is
not formatted.
There is an error in the
internal memory.
The camera is not connected
to the printer correctly.
There is no paper in the
printer.
The printer has run out of ink. Replace the ink cartridge in the printer.
The paper is jammed.
Corrective action
The recorded image has been protected
(read-only) on a computer. Download the
image to a computer and cancel the read-
only setting.
Insert a card or erase unwanted data.
Before erasing, backup the data of
important pictures onto the card, or
download such pictures to a computer.
Replace the card or erase unwanted data.
Before erasing, download important pictures
to a computer.
The internal memory or the card contains
no pictures.
Record pictures.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
Use image processing software to edit the
pictures.
Close the battery compartment/card cover.
Charge the battery.
Format the card or replace.
• Select [POWER OFF] and press .
Insert a new card.
[YES] and press .
• Select [FORMAT]
All data on the card is erased.
Select [MEMORY FORMAT]
press  . All data in the internal memory is
erased.
Disconnect the camera and connect it again
correctly.
Load some paper in the printer.
Remove the jammed paper.
[YES] and