Care And Cleaning - GE Profile OPAL 2.0 XPIO13BCBT Owner's Manual

Care and Cleaning

Descaling and Sanitizing
To keep nugget ice tasting fresh and ice maker performing
Descaling is recommended for removing hard mineral
deposits and should be performed every 4 weeks
depending on water hardness.
Sanitizing
cleaning schedule may need to be adjusted based on
hardness of water.
Cleaning the Bin and Tray
To clean the ice bin, remove the ice bin from the ice
maker and clean with a soft cloth dampened with soapy
solvents or chemicals.
How to Drain Your Opal
Before You Drain:
connected
• The side tank base will have residual water present. Empty
the side tank base of any residual water.
Draining Your Opal
tank base and drape them into your sink, a bowl, a bucket,
Pull to the left to unhook
49-1000464 Rev. 14
Cleaning the Exterior
then use a soft cloth dampened with soapy water to gently
use soap to clean the reservoir. Use a soft cloth moistened
with water.
WARNING
cleaning with bleach, use bleach in a well ventilated area
WARNING
hand, and when not in use.
The drip tray should be wiped dry. Water left in this area
may leave deposits. To clean the drip tray, remove the tray
Do not use from Opal and use a soft cloth dampened with mild soapy
not use solvents or chemicals.
• Allow the water to drain out naturally or tap the "Clean"
button to pump the water out of the system into the nearby
vessel.
• Once water stops flowing, reconnect the drain tubes to the
attached to
the side tank
Unplug the product before cleaning by
Do
7