GE Profile OPAL 2.0 XPIO13BCBT Owner's Manual page 8

Care and Cleaning
How to Descale / Sanitize
Before You Descale/Sanitize:
• Unplug your Opal
• Once draining is complete, reconnect both tubes to the
• Uninstall all accessory filters and replace mesh screen
Starting your Descale
deposits from the ice system.
2. Plug in your Opal and hold the "Clean" button to initiate
a 55 min descale cycle.
3. Once the descale cycle is complete, rinse your Opal
Rinsing Your Opal
3. Tap the "Clean" button to initiate a 3 min rinse cycle.
4. After the rinse cycle is completed, disconnect tubes,
drain water, reconnect tubes, and refill with fresh
water.
3 & 4, 2 more times – complete 3 total
rinses
6. Once rinsing is complete, reconnect the drain tubes
reconnect the unlabeled tube to the drain plug, and
WARNING
Scalding Hazard
Water temperatures coming from tap are dependent on
water heater settings. Water temperatures above 125°
(52°
the disabled. and the elderly are at highest risk of being
scalded. Use caution when descaling with hot water.
8
Starting your Sanitize
hygienic and tasting great.
reservoir of water.
2. Plug in your Opal and tap the "Clean" button to initiate a
49-1000464 Rev. 14