Lighting Instructions - DCS BGB131 Use And Care Manual

LEAK TESTING & LIGHTING INSTRUCTIONS
WARNING:
Do not smoke while leak testing. Extinguish all open flames.
Make a soap solution of one part liquid
detergent, and one part water. Never test for
leaks with an open flame. For LP units, check
with a full cylinder. Make sure all control valves
are in the "OFF" position. Turn the gas supply
"ON" . Check all connections from the supply line
(Fig. 02), or LP cylinder (Fig. 03) up to the
manifold pipe assembly (Fig. 05). Apply the soap
solution around the connection with a spray
bottle, brush, or rag. Soap bubbles will appear
where leak is present. If a leak is present, turn off
gas supply, tighten any leaking fittings, turn gas
on, and recheck.
WARNING: IMPORTANT!
Inspect the gas supply piping or hose prior to turning the gas "ON" . If there is
evidence of cuts, wear or abrasion, it must be replaced prior to use. Do not
use the Professional Side Burner if the odor of gas is present. Turn the control
knob to "OFF" , then turn off the gas supply. If using LP, is there gas in the
tank? Always keep your face and body as far away from the burner as
possible when lighting.

LIGHTING INSTRUCTIONS

First remove the burner cover and any cooking utensils
from the burner grate. Push and hold the ignition
button, turn the control knob to the "HI" position until
the burner is lit or 4 seconds pass. If the burner doesn't
ignite, wait 5 minutes for any accumulated gas to
dissipate then try again. If the burner will not light after
several attempts, check
instructions on page 14. To light burner manually see
page 11,"Match Lighting" .
the troubleshooting
10
FIG.05
Control
Ignition
Knob
FIG. 06 BGB132 Shown