Terminal Panel Features - NEC VT800 User Manual

Terminal Panel Features

The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not
affect the projector's performance.
1. COMPUTER1 IN/COMPONENT 1 IN Connector
(Mini D-Sub 15 Pin)
(→ page 11, 13, 15)
AUDIO IN (Stereo Mini Jack)
(→ page 11, 13, 15)
2. COMPUTER2 IN/COMPONENT 2 IN Connector
(Mini D-Sub 15 Pin)
(→ page 11, 15)
AUDIO IN (Stereo Mini Jack)
(→ page 11)
3. HDMI IN (19 Pin HDMI Type A)
(→ page 12, 14)
4. S-VIDEO IN Connector (Mini DIN 4 Pin)
(→ page 16)
AUDIO L/MONO, R (RCA)
(→ page 16)
5. VIDEO IN Connector (RCA)
(→ page 16)
AUDIO L/MONO, R (RCA)
(→ page 16)
6. MONITOR OUT Connector (Mini D-Sub 15 Pin)
(→ page 13)
AUDIO OUT (Stereo Mini Jack)
(→ page 13)
4
8 9
LAN
USB
COMPUTER /
COMPONENT 1 IN
S-VIDEO IN AUDIO IN
MONITOR OUT
L/MONO R
VIDEO IN AUDIO IN
L/MONO R
5
1
COMPUTER /
COMPONENT 2 IN
AUDIO IN
AUDIO OUT
PC CONTROL
6 7
7. PC CONTROL Port (D-Sub 9 Pin)
(→ page 130, 131)
Use this port to connect your PC or control system
to control your projector via a serial cable. This
enables you to control the projector using serial
communication protocol. A commercially available
RS232C cross cable is required to use this port.
You can also control the projector by using PC Con-
trol Utility 3.0 (downloadable from our website:http:
www.nec-pj.com). To do so you must fi rst have PC
Control Utility 3.0 installed on your PC. If you are
writing your own program, typical PC control codes
are on page 130.
8. USB Port (Type A)
(→ page 33)
9. LAN Port (RJ-45)
(→ page 18, 98)
7
3
HDMI IN
AUDIO IN
2
1. Introduction