Turning Off The Projector; After Use - NEC NP2150 User Manual

 Turning off the Projector

To turn off the projector:
1. Press the POWER (ON/STAND BY) button on the projector
cabinet or the POWER OFF button on the remote control.
The [POWER OFF / ARE YOU SURE?] message will appear.
2. Press the ENTER button
After the projector turns off, the cooling fans keep operating for
a while (Cooling-off time).
The cooling fans stop operating when the projector turns off
and goes into standby mode.
When in standby mode, the POWER indicator will light orange
and the STATUS indicator will light green.
3. After making sure that the projector is in standby mode, turn
off the Main Power switch. The power indicator will go out.
About Direct power Off
The projector has a feature called "Direct Power Off". This fea-
ture allows the projector to be turned off (even when projecting
an image) using a power strip equipped with a switch and a
breaker.
NOTE: Before using Direct Power Off, be sure to allow at least 20 min-
utes immediately after turning on the projector and starting to display
an image.
CAUTION
• Do not unplug the power cable from the wall outlet or projec-
tor when the projector is powered on. Doing so can cause
damage to the AC IN connector of the projector and (or)
the prong plug of the power cable. To turn off the AC power
supply when the projector is powered on, use a power strip
equipped with a switch and a breaker.
• Do not turn off the AC power supply within 10 seconds of
making adjustment or setting changes and closing the menu.
Doing so can cause loss of adjustments and settings and re-
turn to default.
TIP: The projector can be unplugged during its cool down period after it is turned off.

 After Use

preparation: Make sure that the main power is turned off.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt feet if extended.
4. Cover the lens with the lens cap.
3. Projecting an Image (Basic Operation)
3D.REFORM AUTO.ADJUST
AUTO.ADJUST
3D.REFORM

POWER
OFF
COMPUTER
1
VIDEO
COMPONENT
S-VIDEO
USB
LAMP
STATUS
SELECT
SOURCE ON/STAND.By POWER
POWER
OFF
COMPUTER
1
VIDEO
COMPONENT
S-VIDEO
USB
LAMP
STATUS
SELECT
ON/STAND.By POWER
SOURCE
POWER
ON
2
VIEWER
3
NETWORK
POWER
ON
2
VIEWER
3
NETWORK