1. Manuals
  2. Brands
  3. Qoltec Manuals
  4. IP Access Controllers
  5. 52440
  6. Manual

Qoltec 52440 Manual

Hide thumbs Also See for 52440:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Model: 52440, 52441

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 52440 and is the answer not in the manual?

Questions and answers

Related Manuals for Qoltec 52440

Summary of Contents for Qoltec 52440

  • Page 1 Model: 52440, 52441...

  • Page 2: About The Product

    INTRODUCTION Thank you for your trust and for choosing the FEBE Qoltec combination lock. We are convinced that the product will meet your expectations. This manual will guide you through the installation and use of the unit. It contains important safety instructions for operation and correct installation. If you have any questions after reading the manual, please contact Customer Service.
  • Page 3 Nominal voltage DC 12V±10% Load < 100mA Max. number of users 1000 Keyboard Proximity reader Reading range 1-15cm Ambient temperature ℃0-℃60 10 Moisture 20%-80% 11 Programming code 123456 12 Degree of protection IP68 13 Installation Surface mounting 14 Dimensions 120×78×22(mm) 15 Net weight 110g Factory default settings...

  • Page 4: Installation

    1 long signal Programming Continuous signal Resetting the factory programming password INSTALLATION To install the FEBE combination lock correctly, refer to the information in the table below and Figure 1. Designatio Colour Function +12V Power+ black Power- PUSH blue Low output level OPEN yellow Door release...
  • Page 5 programming password # Adding a user # programming If multiple cards are added, the cards card password # 1 card should be read continuously. reading # Set a common # programming There is only one common access access password password # 21 card password.
  • Page 6 mode password # 6 XX ## or access password)/ 03 (card+PIN). password Reader settings # programming The device can be used as a reader (optional) password # 6 04 ## (W26 output). password Safety function # programming XX can be set to 01/02 (safety function settings password # 7 # OFF/ON) and 03/04 (disassembly alarm...
  • Page 7 READING MDC >> READING To delete a card user in standby mode REGISTERED CARDS >> READING MDC MDC READ >> MAC READ >> MDC To delete all users in standby mode READ User identification number The user ID is an automatically generated 4-digit number starting from 0001.This number increases as users are added and does not take into account the deletion of users.
  • Page 8 ATTACHMENT...

This manual is also suitable for:

52441

Table of Contents