MSI K8N Diamond User Manual page 66

This is specified in units of 0.5ns. The controller needs to know when to enbale
its DQS receiver in anticipation of the DRAM DQS driver truning on for a read.
The controller will disable its DQS receiver until the read preamble time and then
enable its DQS receiver while the DRAM asserts DQS. Setting options: [2ns], [2.
5ns], [3ns], [3.5ns], [4ns], [4.5ns], [5ns], [5.5ns], [6ns], [6.5ns], [7ns], [7.5ns],
[8ns], [8.5ns], [9ns], [9.5ns].
Async Latency value
When the User Config mode is set to [Manual], the field is adjustable. This field
should be loaded with 4-bit value equal to th e maximum asynchronous latency
in the DRAM read round-trip loop. Setting options: [2ns], [3ns], [4ns], [5ns],
[6ns], [7ns], [8ns], [9ns], [10ns], [11ns].
S/W & H/W memory hole Remapping
This field enables software/hardware to remap the physical memory to the
address higher than 00E0. (This item only activities in 64-bit OS) Setting options:
[Disabled], [Enabled].
MTRR M apping Mode
This field allows you to control the MTRR mapping Mode. Setting options:
[Disabled], [Continuous].
Aggressive timing
This item allows you to enable or disable the memory clock. When [Enabled] is selected,
the timing delay of memory will be shorten to increase the performance. Setting
options: [Enabled], [Disabled].
Dynamic Overclocking
Dynamic Overclocking Technology is the automatic overclocking function, included in
's newly developed CoreCell
TM
the MSI
balance of CPU while running programs, and to adjust the best CPU frequency
automatically. W hen the motherboard detects CPU is running programs, it will speed
up CPU automatically to make the program run smoothly and faster. W hen the CPU is
temporarily suspending or staying in the low load balance, it will restore the default
settings instead. Usually the Dynamic Overclocking Technology will be powered only
when users' PC need to run huge amount of data like 3D games or the video process,
and the CPU frequency need to be boosted up to enhance the overall performance.
Setting options:
[Disabled] Disable Dynamic Overclocking function.
[Private] 1st level of overclocking, increasing the CPU frequency by 1%.
[Sergeant] 2nd level of overclocking, increasing the CPU frequency by 3%.
[Captain] 3rd level of overclocking, also the default value of "Load High
Performance Defaults", increasing the CPU frequency by 5%.
[Colonel] 4th level of overclocking, increasing the CPU frequency by 7%.
[General] 5th level of overclocking, increasing the CPU frequency by 9%.
[Commander] 6th level of overclocking, increasing the CPU frequency by 11%.
TM
Technology. It is designed to detect the load
BIOS Setup
3-23