Serial Ata/Serial Ata Raid Connectors Controlled By Ich5R: Ser1, Ser2 (Optional) - MSI 875P Neo-FIS2R User Manual

Serial ATA/Serial ATA RAID Connectors controlled by ICH5R:
SER1, SER2 (Optional)
The Southbridge of this mainboard is ICH5R which supports two serial
connectors SER1 & SER2.
SER1 & SER2 are dual high-speed Serial ATA interface ports. Each sup-
st
ports 1 generation serial ATA data rates of 150 MB/s. Both connectors are
fully compliant with Serial ATA 1.0 specifications. Each Serial ATA connector
can connect to 1 hard disk device. Please refer to the Appendix B: Intel ICH5R
Serial ATA Raid Introduction for detail software installation procedure.
1
7
Serial ATA cable
Connect to serial ATA ports
MSI Reminds You...
Please do not fold the serial ATA cable in a 90-degree angle,
which will cause the loss of data during the transmission.
SER1~ SER2 Pin Definition
SER2
PIN SIGNAL
SER1
1 GND
3 TXN
5 RXN
7 GND
Hardware Setup
PIN SIGNAL
2 TXP
4 GND
6 RXP
Take out the dust cover and
connect to the hard disk
devices
2-17