Switching Off Water Softening System; Regeneration Of The Water Softening System - Bosch SMV88UX36E User Manual

en Water softening system
1
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Place the lid back on the dis-
4.
penser and turn to close.
Switching off water softening
system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
salt refill indicator off.
Note
To avoid damage to the appliance, only
switch off the water softening system in
the following cases:
¡ The water hardness is max. 26 °E
and you are using combined deter-
gents with salt replacement sub-
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gen-
erally only be used up to a water
hardness of 26 °E without adding
special salt.
¡ The water hardness is 0 - 8 °E.
You do not need to use special
salt.
1
Depending on the appliance specifications
32
1.
2.
a
3.
4.
a The water softening system is
Regeneration of the water
softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs reheating of the water
softening system at regular intervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
grammes. It will increase the run time
and consumption values, e.g. water
and electricity.
To open the basic settings, press
for approx. 3 seconds.
Press repeatedly until the display
shows "Water hardness".
Press or repeatedly until the
display shows 0 - 6.
To save the settings, press
approx. 3 seconds.
switched off and the salt refill indic-
ator is deactivated.
for