Advertisement
Advertisement
Table of Contents
Related Manuals for Awake RAVIK
Summary of Contents for Awake RAVIK
- Page 2 It’s soon time to go out riding! v. 2.0...
- Page 3 Welcome to Awake! Read this guide, and you’ll be good to go!
- Page 4 Welcome You are now part of the Awake-movement! At Awake, it is not about making just another watersports product. Awake is much more than that. We are energetic, adventurous and committed thrill seekers, and we want to pass our passion on. Through technology...
- Page 5 Welcome to Awake!
-
Page 6: Inventory List
User manual Warranty card * The inventory list covers one (1) standard Awake RÄVIK package. If you’ve added additional accessories, such as board bag kit, impact vest, extra fins, etc., these will also be included in the box. Extra batteries and their hand controllers are shipped separately. - Page 7 Awake’s electric surfboard models – RÄVIK ONE, RÄVIK 3, and RÄVIK S. BP is the abbreviation of Awake’s battery – ’Battery Pack’. XR is short for ’Extended Range’, and is used to define Awake’s larger battery; the ’XRBP’, as well as a board that has been upgraded with an XRBP;...
- Page 8 QR-code below and make sure that bluetooth is activated on you smartphone. 2. Activate the Flex BP with a PKL and open the Awake app. Stay close to the battery pack you want to connect too and choose your battery from the list. When connected, the LEDs on you Flex BP will turn blue.
- Page 9 Welcome to Awake! Welcome to Awake! AWAKE APP...
- Page 10 Awake Flex Hand Controller (HC) The Awake Flex HC is the wireless device that controls the speed of your board. It can be paired to any Flex BP and is charged by the Awake Flex Hand Controller Charger. Display Throttle button...
- Page 11 Pairing the Flex HC to the Flex BP 1. Connect to the Flex BP and open the QR-reader in the Awake App. 2. Scan the QR-code on the Flex HC display. 3. The Flex BP will “beep” when the Flex HC is paired correctly.
- Page 12 Awake Flex Battery Pack (BP) The Awake Flex BP is the energy source of your RÄVIK. There are two dif- ferent capacity sizes to choose from, the Standard Range (SR) and the Extended Range (XR). Regardless of capacity size, all Flex BPs fit into all Awake Boards, RÄVIK and VINGA alike.
- Page 13 Welcome to Awake! Charging the Flex BP Charging times: SR ~1,5h / XR ~2h 1. Plug in the Flex Charger to a power outlet. 2. Grab and lift the Flex BP with the Handle and the Locking Handle. 3. Carefully place the Flex BP on...
-
Page 14: Before The Ride
Make sure to connect your Flex BP(s) to the app for a quick equipment status check, login to or create your own Awake Account and make sure to register all your gear in the Gear garage. If an update is available for your Flex BP, install it and put the Flex BP on the charger until fully charged. - Page 15 Welcome to Awake! Install the fins 1. The Awake RÄVIK ONE has a quad-fin system and the 3/S a twin fin system for increased performance 2. The fins have one flat and one convex side. The convex side should be facing away from the board 3.
- Page 16 During the ride Activate the HC 1. Activate the HC by pressing the throttle down firmly all the way down and then release. 2. The HC deactivates/shuts off automatically after 45 seconds. Simply repeat the activation procedure to reactivate it Activate the board 1.
-
Page 17: After The Ride
Welcome to Awake! After the ride 1. Rinse the board and accessories with fresh water After finishing a ride, make sure that everything is rinsed down properly with fresh water. Don’t be afraid of getting everything properly wet, all the components (including the male/female connectors) are individually water proof when the PKL is disconnected. - Page 18 LEDs) to enjoy the full capacity of you Flex BP. Failure to store the Flex BP at a recommended state of charge can deplete the cells beyond recovery and render the entire Flex BP unusable (an action not covered by the Awake Care © or warranty).
- Page 19 Welcome to Awake! [NOTICE]: NEVER do any of the following: 1. Never connect or disconnect the Flex BP to the board in the water. It’s important that the male connector found in the Flex BP compartment of the board, and the female connector found on the Flex BP are always dry when connecting.
-
Page 20: Stay Awake
Stay up-to-date with offers, news and tips. Explore all Awake products and subscribe to our newsletter by scanning the QR-code See you out there! If you experience any issues with your Awake products please contact Awake Support through the Awake app or support@awakeboards.com. - Page 21 Welcome to Awake! Welcome to Awake!
-
Page 22: Owner's Notes
Owner’s notes... - Page 24 Make sure to follow us at on Instagram (@awakeboards) for inspiration on adventures to take your Awake Board on, and share your rides with us at #rideawake Subscribe to our newsletter to stay up-to-date with offers, news, tips, and much more! awakeboards.com/stayawake...
Need help?
Do you have a question about the RAVIK and is the answer not in the manual?
Questions and answers