Door Reversibility - AEG ORT541EW User Manual

8 www.aeg.com
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.
3.4 Levelling
When placing the appliance make sure
that it stands level. This can be achieved
by two adjustable feet at the bottom in
front.

3.5 Door reversibility

WARNING!
Before carrying out any
operations, remove the plug
from the power socket.
1. Make sure the appliance stands
upright.
2. Open the door and remove the door
equipment. Refer to the "Daily Use"
chapter. Close the door.
3. Remove the upper hinge cap and pry
out the plug buttons. Put them
together in a safe space.
4. Unscrew the screws that connect the
upper hinge. Put the upper hinge in a
safe place together with the screws.
5. Lift the door and put it on a soft
surface.
6. Tilt the appliance carefully on a soft
foam packaging or similar material to
avoid any damage to the back of the
appliance and the floor.
7. Remove the upper plug and transfer
it to the uncovered hole of the upper
hinge on the other side of the
appliance. Press the plug firmly into
the hole.
8. Unscrew the screws of the bottom
hinge and adjustable feet. Transfer
them to the other side of the
appliance.
9. Install the pin in the opposite hole of
the hinge.
10. Screw the bottom hinge on the other
side of the appliance.
11. Install the rubber support on the side
with no hinge.
12. Install the adjustable feet.
13. Fit the door on the lower hinge
making sure the hinge pin enters the
door bottom hole.
14. Install the upper hinge on the
opposite side of the appliance. Fit the
upper hinge pin into the door upper
hole. Tighten the screws.
15. Screw the remaining 2 screws on the
top side of the appliance with no
hinge.
16. Insert the plug buttons into the
uncovered holes.
17. Replace the upper hinge cap.
Install the door equipment.
Wait at least 4 hours before connecting
the appliance to the power supply.