Welcome to Electrolux! Thank you for choosing our appliance. Get usage advice, brochures, troubleshooting, service and repair information: www.electrolux.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. PRODUCT DESCRIPTION................6 4. CONTROL PANEL..................7 5.
• Children of less than 3 years of age should be kept away from the appliance unless continuously supervised. • Children should be supervised to ensure that they do not play with the appliance. • Keep detergents away from children. •...
• If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused.
Page 5
2.4 Use sensors, software and firmware including reset software. The following spare parts • Do not put flammable products or items are available for at least 10 years after the that are wet with flammable products in, model has been discontinued: door hinge near or on the appliance.
3. PRODUCT DESCRIPTION Ceiling spray arm Lower basket Upper spray arm Upper basket Lower spray arm Cutlery drawer Filters Rating plate The graphic is a general overview. For Salt container more details, refer to other chapters or documents provided with the appliance. Air vent Rinse aid dispenser Detergent dispenser...
4. CONTROL PANEL On/off button Option button Program button Indicators Programme indicators Start button Display Delay button 4.1 Indicators Indicator Description Salt indicator. It is on when the salt container needs refilling. It is always off while the pro‐ gramme operates. Rinse aid indicator.
5. PROGRAMMES The order of the programmes in the table may not reflect their sequence on the control panel. Programme Dishwasher Degree of Programme phases Options load soil Crockery, cut‐ Normal, lightly • Prewash • ExtraPower lery, pots, pans dried-on •...
Programme Dishwasher Degree of Programme phases Options load soil • Prewash This programme offers the most efficient use of water and energy consumption for crockery and cutlery with normal soil. This is the standard programme for test institutes. This programme is used to assess compliance with the Ecodesign Comission Regulation (EU) 2019/2022.
6. OPTIONS prevents rapid changes in the dishwashing temperature of the selected programme and reduces it to 45 °C. Desired options must be activated every time before you start a programme. It is not possible to activate or deactivate How to activate GlassCare options while a programme is running.
flash and the How to set the programme selection display is blank. mode The appliance is in programme selection 7.2 The water softener mode when the programme indicator The water softener removes minerals from on and the display shows the programme the water supply, which would have a duration.
Regeneration process when it occurs at any point at the beginning For the correct water softener operation, the or in the middle of a programme. resin of the softener device needs to be regenerated regularly. This process is automatic and is the part of the normal All the consumption values mentioned in dishwasher operation.
• The display shows the current setting. When AirDry opens the door, the display shows the remaining time of the running – = the rinse aid empty programme. notification is deactivated. – = the rinse aid empty CAUTION! notification is activated. Do not try to close the appliance door 2.
8.2 How to fill the rinse aid The salt is used to recharge the resin in the dispenser water softener and to assure good washing results in daily use. How to fill the salt container 1. Turn the cap of the salt container counterclockwise and remove it.
9.2 Setting and starting a • If the rinse aid indicator is on, fill the programme rinse aid dispenser. 3. Load the baskets. 4. Add the detergent. The Auto Off function 5. Set and start a programme suitable for the type of load and the degree of soil. This function decreases energy consumption 9.1 Using the detergent by deactivating automatically the appliance...
energy consumption and the programme Press and hold simultaneously duration. After closing the door, the appliance until the appliance is in programme selection continues from the point of interruption. mode. Cancelling the programme If the door is opened for more than 30 seconds during the drying phase, the Press and hold simultaneously running programme ends.
– Make sure that the current level of the 3. Start the shortest programme with a water softener agrees with the rinsing phase. Do not add detergent and hardness of the water supply. do put dishes in the baskets. – Follow the instructions in the chapter 4.
10.6 Unloading the baskets 1. Let the tableware cool down before you After the programme is completed, water remove it from the appliance. Hot items can still remain on the inside surfaces of can be easily damaged. the appliance. 2. First remove items from the lower basket, then from the upper basket.
2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 11.5 Cleaning the lower spray arm We recommend to clean the lower spray arm regularly to prevent soil from clogging the holes.
1. Release the stoppers on the sides of the sliding rails of the cutlery drawer and pull 3. To install the spray arm back, press it the drawer out. downwards. 11.6 Cleaning the upper spray arm 2. Move the upper basket to the lowest level to reach the spray arm more easily.
5. To install the spray arm (C) back, insert the mounting element (B) in the spray arm and fix it in the delivery tube (A) by turning it clockwise. Make sure that the mounting element locks into place. 6. Install the cutlery drawer on the sliding rails and block the stoppers.
Page 22
Problem and alarm code Possible cause and solution The anti-flood device is on. • Close the water tap. The display shows i30. • Make sure that the appliance is correctly installed. • Make sure the baskets are loaded as instructed in the user manual. Malfunction of the water level detec‐...
Page 23
Problem and alarm code Possible cause and solution The appliance trips the circuit-beak‐ • The amperage is insufficient to supply simultaneously all the applian‐ ces in use. Check the socket amperage and the capacity of the meter or turn off one of the appliances in use. •...
Problem Possible cause and solution Unusual foam during • Use the detergent designed specifically for dishwashers. washing. • Use a detergent from a different manufacturer. • Do not pre-rinse dishes under running water. Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water soften‐ er".
Capacity Place settings Refer to the rating plate for other values. If the hot water comes from alternative source of energy (e.g. solar panels), use the hot water supply to de‐ crease energy consumption. 13.1 Link to the EU EPREL database database using the link https:// eprel.ec.europa.eu and the model name and The QR code on the energy label supplied...
Need help?
Do you have a question about the ESS48305UW and is the answer not in the manual?
Questions and answers