DeWalt 12AVP2KL347 Instruction Manual

Self-propelled mower

Hide thumbs

Table Of Contents

Quick Links

Download this manual

Instruction Manual

12AVP2KL347

Self-Propelled Mower

11A-B9KL347

Push Mower

If you have questions or comments, contact us.

1300-951-594

Form No. 769-26766

(March 6, 2023)

Table of Contents

Need help?

Do you have a question about the 12AVP2KL347 and is the answer not in the manual?

Questions and answers

Summary of Contents for DeWalt 12AVP2KL347

Page 1 Instruction Manual 12AVP2KL347 Self-Propelled Mower 11A-B9KL347 Push Mower If you have questions or comments, contact us. 1300-951-594 Form No. 769-26766 (March 6, 2023)
Page 2 English (original instructions) © 2023 DEWALT. DEWALT® and GUARANTEED TOUGH® are registered trademarks of the DEWALT Industrial Tool Co., used under license. All rights reserved. The yellow and black color scheme is a trademark for DEWALT Power Tools and Accessories.
Page 3 Definitions: Safety Alert Symbols and Words This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
Page 4: Safe Operation Practices
SAFE OPERATION PRACTICES WARNING: This symbol points out Preparation Before Operating important safety instructions which, if not 1. Thoroughly inspect the area where the mower is to followed, could endanger the personal safety be used. Remove all stones, sticks, wire, bones, toys, and/or property of yourself and others.
Page 5 SAFE OPERATION PRACTICES, cont'd c. Pull the mower back slowly, no more than half 14. A missing or damaged discharge door, chute or way toward you. mulch plug can cause blade contact or thrown object injuries. d. Repeat these steps as needed. 15.
Page 6 SAFE OPERATION PRACTICES, cont'd Slope Operation for Walk-Behind 6. Never store the mower or fuel container inside where there is an open flame, spark or pilot light Mowers as on a water heater, space heater, furnace, clothes 1. Slopes are a major factor related to slip and fall dryer or other gas appliances.
Page 7: Spark Arrestor
SAFE OPERATION PRACTICES, cont'd 6. Regularly check the safety interlock system for When required, models are equipped with proper function, as described later in this manual. low permeation fuel lines and fuel tanks for If the safety interlock system does not function evaporative emission control.
Page 8 SAFE OPERATION PRACTICES, cont'd This page depicts and describes safety symbols that may appear on this mower. Read, understand, and follow all instructions on the mower before attempting to assemble and operate. Symbol Description WARNING — READ THE OPERATOR’S MANUAL(S) - Read, understand and follow all the safety rules and instructions in the manual(s) and on the mower before attempting to operate this mower.
Page 9: Mower Assembly
ASSEMBLY Handle Assembly IMPORTANT: This mower is shipped without gasoline or oil in the engine. Be certain to service engine with Pull-Out Handle gasoline and oil as instructed in the Operation section 1. Remove knobs or wing nuts (a) and carriage bolts of the Engine Manual before starting or operating (b) from the handle (Figure 1).
Page 10: Folding Handle
ASSEMBLY, cont'd 5. Reattach knobs or wing nuts (a) and carriage bolts 2. Remove the T-bolts (c) from the handle brackets (b) removed in STEP 2 into the handle (Figure 4). (Figure 5). 3. While stabilizing mower so it doesn’t move, gently lift and pivot the upper handle into the operating position (Figure 6).
Page 11: Attaching The Grass Catcher
ASSEMBLY, cont'd Recoil Starter Rope Handle Assembly NOTE: The rope guide is attached to the right side of the upper handle. Loosen the knob securing the rope guide (Figure 8). NOTE: Select units include a slip knot in the recoil starter rope to reduce slack during shipping.
Page 12: Cutting Height Adjustments
ASSEMBLY, cont'd Attaching Side Discharge Chute (If IMPORTANT: All wheels must be placed in the same position. For rough or uneven lawns, move each height Equipped) adjustment lever to a higher position. This will prevent The mower is shipped as a mulcher. To convert to side you from cutting the grass too close to the ground.
Page 13: Controls And Operation
CONTROLS & OPERATION Figure 15 Features C. CUTTING HEIGHT ADJUSTMENT LEVER The dual lever cutting height adjustment levers are A. BLADE CONTROL located above the front and rear wheels. To adjust the The blade control is attached to the upper handle of cutting height, refer to Cutting Height Adjustment on the mower.
Page 14 CONTROLS & OPERATION, cont'd To Stop Engine G. REAR MULCH PLUG (IF EQUIPPED) On select mowers, the mulch plug is a separate Release blade control to stop the engine and blade. component. If equipped, this mulch plug must be NOTE: If equipped with an electric starter push key, installed into the rear bagging discharge area when remove the key when the mower is unattended to using the mower as a mulcher (recirculating the...
Page 15 CONTROLS & OPERATION, cont'd Using Mower with Grass Catcher NOTE: When selecting a drive speed, use the first speed until you are comfortable and familiar with the (If Equipped) operation of the mower. You can use the grass catcher to collect clippings while IMPORTANT: If you are shifting speeds while the you are operating the mower.
Page 16: Product Care
PRODUCT CARE WARNING: Before performing any type of Clean Engine maintenance/service, disengage all controls • Before every use, clean grass, chaff or accumulated and stop the engine. Wait until all moving debris from engine. Keep linkage, spring, and parts have come to a complete stop. Allow controls clean.
Page 17: Deck Cleaning
PRODUCT CARE, cont'd Deck Cleaning 5. Remove blade (c) and blade adapter (d) from the crankshaft At least once a season and before storage, clean the (Figure 19). underside of the mower deck to prevent build-up of 6. Remove blade from the blade adapter for testing grass clippings or other debris.
Page 18: Customer Support
PRODUCT CARE, cont'd Belt Care Customer Support A damaged or worn belt may prevent the mower from For machines needing service or parts self-propelling. Periodically inspect the belt and pulley replacement please contact your local D WALT ® system for damage or wear. If necessary contact an Service Center or the Customer Support authorized Service Center to have belt replaced.
Page 19: Warranty
WARRANTY MTD Product Warranty Statutory Warranty If you are a “consumer” pursuant to the Australian Consumer Law, then MTD Products Australia Pty Ltd ACN 004 873 572 (MTD) confirms the following: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.
Page 20 2 Year Domestic / 90 Day Rover Alloy Deck / Non-Rover Engine 5 Years 90 Days Commercial 3 Year Domestic / 3 Years DEWALT Steel Deck 3 Years 90 Days Commercial 2 Year Domestic / 90 Day 1 Year Domestic / 90 Day...
Page 21 1 Year Domestic / 90 Rover RZT S 46 Kohler 5 Years 90 Days Day Commercial Day Commercial 3 Year Domestic / 90 1 Year Domestic / 90 DEWALT 42/20 Kohler 3 Years 90 Days Day Commercial Day Commercial 3456-1900-8267v1...
Page 22 WARRANTY, cont'd TABLE A CONTINUED General Warranty General Warranty Period Domestic Period Commercial CUB CADET RIDE ONS & ZERO- Engine Warranty Attachment Warranty TURNS Period Period Excludes engine, attachments and normal wear parts 1 Year Domestic / Nil Electric Riders & Zero-Turn 3 Years 90 Days Commercial...
Page 23 WARRANTY, cont'd TABLE A CONTINUED General Warranty General Warranty CUB CADET COMMERCIAL Period Period Domestic Use Commercial Engine Warranty Period Attachments Warranty Period Excludes engine, attachments and Handheld normal wear parts Brush Cutter 3 Years 1 year 1 year Hedge Trimmer 3 Years 1 year 1 year...
Page 24 WARRANTY, cont'd TABLE A CONTINUED General Warranty Period Domestic & WOLF- Garten Engine Warranty Period Attachments Warranty Period Commercial Use WOLF-Garten multi-Star® unit system, multi-star® Minis and the multi-star® tree Lifetime care without ladder Hand tools and all manually controlled 10 years trimmers For the purpose of Table A:...
Page 25 WARRANTY, cont'd any failure arising from accident, abuse, act of God, fire, sabotage, vandalism, contaminated fluids or neglect or failure to operate, store and/or maintain and service the MTD Product in accordance with the instruction manual supplied with the MTD Product; any parts or services required for the normal and regular maintenance of the MTD Product e.g.
Page 26 WARRANTY, cont'd full details of the alleged MTD Product defect. to an authorised MTD dealer upon discovery of any defect in the MTD Product, and within the relevant Warranty Period. Your nearest MTD dealer can be found at cubcadet.com.au, rover.com.au or mtd.com.au.
Page 27 NOTES...
Page 28 NOTES...
Page 29 NOTES...
Page 30 NOTES...
Page 31 NOTES...
Page 32: Slope Gauge
SLOPE GAUGE...

This manual is also suitable for:

11a-b9kl347