E-peas AEM10330 Quick Start Manual

Evk

Download this manual

AEM10330

Quick Start Guide EVK

FEATURES

Connectors

• 1 screw connector for the source.

• 1 screw connector + 1 JST connector for the storage element.

• 1 screw connector for the application circuit.

• 1 screw connector for RZMPP.

Configuration

• 3 headers R_MPP[2:0] to configure the source MPP ratio.

• 2 headers T_MPP[1:0] to configure the source MPP timings.

• 4 headers STO_CFG[3:0] to configure the storage element protection levels.

• 4 resistor footprints, R1 to R4, related to the custom mode (STO_CFG[3:0]=LHHH).

• 2 headers LOAD_CFG[1:0] to configure the LOAD voltage.

• 1 header to set the dual-cell supercapacitor BAL feature.

• 5 headers to configure the different modes.

Size

• 76mm x 49mm.

• 4 x M2.5 mounting holes.

SUPPORT PCB

BOM around the AEM10330

Footprint & Symbol:

Information available in the datasheet.

www.e-peas.com

QSG-AEM10330_EVK1.2-v1.0

Need help?

Do you have a question about the AEM10330 and is the answer not in the manual?

Page 1 • 1 header to set the dual-cell supercapacitor BAL feature. • 5 headers to configure the different modes. Size • 76mm x 49mm. • 4 x M2.5 mounting holes. SUPPORT PCB BOM around the AEM10330 Footprint & Symbol: Information available in the datasheet. www.e-peas.com © 2024 e-peas S.A. QSG-AEM10330_EVK1.2-v1.0...
Page 2 STEP 1: Configure the AEM10330 • Source voltage regulation: R_MPP[2:0] and T_MPP[1:0] • Storage element voltages protection: STO_CFG[3:0] • LOAD voltage: LOAD_CFG[1:0] • BAL option: Select “ToCn” to use the balancing or “GND” to disable it. • Configuration mode: Jumper to H to enable or to L to disable the features: •...
Page 3 STEP 2: Connect the storage element STEP 3: Connect the harvester • Internal boost efficiency Vs. input voltage in Low Power mode: • Internal boost efficiency Vs. input voltage in High Power mode: STEP 4: Check the status www.e-peas.com © 2024 e-peas S.A. QSG-AEM10330_EVK1.2-v1.0...