Data General DASHER D100 Field Engineering Manual page 91

software. The drawings and specifications contained herein are the property of DGC and shall neither be reproduced in whole or in part without DGC's prior written approval nor be implied to
grant any license to make, use, or sell equipment manufactured in accordance herewith.
6. kKemove the defective CkKI from the customer's site and bleed the
BLEEDING CRT VACUUM
Before aisposing of a defective CRT, bleed the vacuum as follows.
WARNINGS Always wear safety glasses and gloves before bleeding the
1. Cut a small nole in the box containing the CRT so you can gain access
to the neck with diagonal cutting pliers.
2. Seal the box using masking tape.
3. Make Sure the area is clear of bystanders.
4, Using diagonal cutters, reach through the hole in the box and cut the
glass nipple protruding from the neck of the tube.