Data General DASHER D100 Field Engineering Manual page 77

Data General Corporation (DGC) has prepared this manual for use by DGC personnel and customers as a guide to the proper installation, operation, and
maintenance of DGC equipment and software. The drawings and specifications contained herein are the property of DGC and shall neither be reproduced in whole or
in part without DGC's prior vritten approval nor be implied to grant any license to make, use, or sell equipment manufactured in accordance herewith.
CHAPTER 8
INSTALLING AND REMOVING FRUS
This chapter contains the procedures for accessina,y removing, and
installing field replaceable units (FRUS). When performing these
Procedures, observe the following general precautions:
@® Ke careful when working with the main printed circuit poard and
the CRIi/yoke assembly. These units carry dangerously high
@® kemove and replace only those components described in the
@ Remove cables by pulling on the connector rather than the
cable, thus preventing cable damage.
The proceagures are presented in the order listed below:
1. Upening and Closing the Display Case
eo. Keyboard Replacement
3. Printed Circuit board and CRT/Yoke Assembly Replacements