Data General DASHER D100 Field Engineering Manual page 85

Data General Corporation (DGC) has prepared this manual for use by DGC personnel and customers as a guide to the proper installation, operation, and
maintenance of DGC equipment and software. The drawings and specifications contained herein are the property of DGC and shall neither be reproduced in whole or
in part without DGC's prior written approval nor be implied to grant any license to make, use, or sell equipment manufactured in accordance herewith.
(TM 3. Wait a full S minutes before continuing (to allow the capacitors to
4. Upen the case until the support rods latch, using the procedure
S. DISCHARGE THE HIGH VULTAGE IN THE CRT as follows (see figure 8.12):
eo Fasten one end of a clip lead to an insulated flateblade
e Clip the other end of the lead to the CRT Support bracket.
@ Carefully push the screwdriver blade unger the rubber anode
cap. ihe onlade must touch the wires under the cap to short
® Kepeat the discharge procedure several times until no snap is
(see figure 8. 15).
Insulated screwdriver | CRT high voltage anode
blue
red
Figure 8,12. Discharging the CRT Figure 8.13 CRT/yoke wires.