6.
If the computer is equipped with a fingerprint reader, release the ZIF connector to which the
fingerprint reader board cable (1) is attached, and then disconnect the fingerprint reader board
cable (2) from the system board.
7.
Lift the front edge of the palm rest (3) until it rests at an angle, and then slide the palm rest
forward (4) until it detaches from the computer.
8.
If the computer is equipped with a fingerprint reader, remove the fingerprint reader board cable
from the opening (5) in the top cover.
9.
Remove the palm rest.
Reverse this procedure to install the palm rest.
Component replacement procedures
99