Compaq Presario,Presario 900 Maintenance And Service Manual page 124

Removal and Replacement Procedures
4. Remove the TM2.5 × 5.0 screw 1 that secures the display
inverter cable ground loop to the heat spreader (Figure 5-25).
5. Disconnect the display inverter cable 2 from the system
board.
6. Remove the TM2.5 × 5.0 screw 3 that secures the display
video cable ground loop to the heat spreader.
7. Disconnect the display video cable 4 from the system board.
8. Remove the display video cable from the routing channels in
the heat spreader and the top cover 5.
Figure 5-25. Removing the Display Screws and
Disconnecting the Display Cables
5–32 Maintenance and Service Guide