Straight Shaping - Grizzly G1035 Instruction Manual

Straight Shaping

The fence assembly is a two-piece, independently
adjustable system. When removing material from
the whole face of your workpiece, the outfeed
fence can be adjusted to provide support for the
workpiece as it passes over the cutter. It may
also be set up for partial face removal.
Figure 31. Fence adjustments.
-24-
4.
Lock the infeed fence in position with the
locking handle.
5.
Turn the shaper ON and advance a test
sample of the desired cut about 8'', then stop.
Swing the test piece away from the cutter and
turn the machine OFF.
6. When the cutter comes to a complete stop,
adjust the outfeed fence to support the new
profiled edge. See Figure 32.
Figure 32. Support workpiece as it is fed.
G1035 Heavy-Duty Shaper