Section 6: Operations; Test Run - Grizzly G1035 Instruction Manual

SECTION 6: OPERATIONS

Wear safety glasses dur-
ing the entire operation
process. Failure to com-
ply may result in serious
personal injury.
Keep loose clothing out
of the way of machin-
ery and keep hair pulled
back during operations.
Disconnect power from
the machine when per-
forming any maintenance,
assembly or adjustments.
Failure to do this may
result in serious personal
injury.
Always
mask when operating
this shaper. Using this
machine produces saw-
dust that may cause short
and long-term respira-
tory illness.
NOTICE
The following section was designed to
give instructions on the basic operations
of this shaper. However, it is in no way
comprehensive of every shaper applica-
tion. WE STRONGLY RECOMMEND that you
read books, trade magazines, or get formal
training to maximize the potential of your
shaper.
-20-
wear a dust

Test Run

Once assembly is complete and adjustments are
done to your satisfaction, you are ready to test
the machine.
DO NOT attempt to investigate or adjust the
machine while it is running. Wait until the
machine is turned off, unplugged and all
working parts have come to a complete stop
before you do anything!
Turn on the power supply at the main panel. Press
the START button. Make sure that your finger is
poised on the STOP button, just in case there's
a problem. The shaper should run smoothly, with
little or no vibration or rubbing noises. Strange or
unnatural noises should be investigated and cor-
rected before operating the machine further.
If the shaper seems to be running correctly,
check the directional switch. The spindle should
be rotating in a counterclockwise direction when
the switch is in the FORWARD position. Run the
Model G1035 for a short time to ensure that the
moving parts are working properly with no exces-
sive vibration. If any problem develops, correct
before attempting to use the machine.
If you can not locate the source of unusual noises,
feel free to contact our service department for
help.
G1035 Heavy-Duty Shaper