Grizzly EXTREME G0514X2 Owner's Manual page 46

Bandsaw
Top View
Figure 28. Blade should be perpendicular (90˚)
to the face of the support bearing.
5.
Tighten the assembly cap screw.
6.
Loosen the cap screw on the support bearing
adjustment shaft.
7.
Place a 0.016" feeler gauge between the
support bearing and the blade, and position
the bearing 0.016" away from the back of the
blade as illustrated in Figure 29.
Side View
Figure 29. Blade should be aligned approxi-
mately 0.016" away from the bearing edge.
-28-
Blade
Support
Bearing
Note: For a quick gauge, fold a dollar bill in half
twice (four thicknesses of a dollar bill is approxi-
mately 0.016") and place it between the support
bearing and the blade as shown in Figure 30.
Figure 30. Dollar bill folded twice to make an
approximate 0.016" gauge.
8. Tighten the cap screw to keep the support
bearing locked in place.
To adjust the lower support bearings:
1. DISCONNECT BANDSAW FROM POWER!
2.
Make sure that the blade is tracking properly
and is correctly tensioned.
3. Familiarize yourself with the lower support
bearing controls shown in Figure 31.
G0513X/G0514X/G0514X3 Extreme Series Bandsaw