Grizzly G0440 Manual Update page 7

. Feed the cable over the pulleys in the black
20
box.
. Fasten the black box to the top of the filter.
21
. Feed the cable through the gasket and box
22
plate, then fasten the box plate to the black
box.
. Secure the stop bead on the right side of the
23
cable, approximately 12" from the end.
. Pull the left side of the cable down until it
24
stops, and secure the stop bead up against
the handle holder.
25. Loop the right side of the cable through a
handle, and pull the handle down to cinch the
cable tight.