Entrust nShield Connect v13.4.5 Install Manual page 42

Chapter 9. Basic HSM, RFS and client configuration
9.2.7.2. Edit IPv6 route entry
To edit a route entry for IPv6:
1. From the front panel menu, select System > System configuration > Network config
> Set up routing > Edit route entry.
The following screen is displayed:
Edit route entry
► 1. 1. 1. 1/ 1
3. 3. 3. 3/ 3
1111:1111:1111:1111:
1111:1111:1111:1111
/128
BACK SELECT
2. Select the IPv6 route to be edited. Press the right-hand navigation button. The
following screen is displayed:
Edit route entry
Enter the IP range
and prefix length:
1111:1111::1111:1111:
1111:1111:1111:1111/128
CANCEL NEXT
3. Edit the IPv6 route entry. Press the right-hand navigation button.
Edit route entry
1111:1111:1111:1111:
1111:1111:1111:1111/128
Enter the gateway
2222:2222:2222:2222
BACK NEXT
4. Enter the IPv6 route gateway. If a link-local address is entered for the IPv6 route
gateway the screen below will be displayed.
Edit route entry
Select an interface
for link-local address:
fe80:2222:2222:2222:
2222:2222:2222:2222
Interface #1
BACK NEXT
nShield Connect v13.4.5 Install Guide 38/72