Gateway Solo 2200 User Manual page 16

16 Gateway Solo™ 2200 Multimedia Notebook
u
Caution: Any unsaved work can be lost if you hold the power button down
for too long.
Remember, when the system is on and set for Suspend/Resume mode, press-
To check/change the power button setting:
1 . Turn the system on.
2 . Press the F2 key when you see the message
3 . Using the Right Arrow key, move to the Power menu.
4 . The first available option is Power button mode:. If the setting displayed is
5 . Press the Spacebar to change the setting.
6 . Press the ESC key to access the Exit menu.
7 . Press Enter to Save changes & exit, then press Enter again, or use the
Press and hold the power button for two seconds to turn the system
completely Off .
ing the power button does not completely turn off the computer and the
system does not reboot . You must press and hold the power button for
two seconds to completely power down the system.
in the lower left corner of the display, before Windows 95 loads,
SETUP
to access the Setup menus. The system beeps, then the Main menu
appears.
the one you want, go to Step 6.
Down Arrow key to select any other option.
Press <F2> to access