Cli Examples; Example 1. Enabling Routing For The Switch - NETGEAR GSM7248NA Administration Manual

CLI Examples

This diagram shows a Layer 3 switch configured for port routing. It connects three different
subnets, each connected to a different port. The script shows the commands you would use to
configure a 7000 Series Managed Switch to provide the port routing support shown in the diagram.
Figure 7-1

Example 1. Enabling routing for the Switch

Use the following command to enable routing for the switch. Execution of the command enables
IP forwarding by default.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit
IP Routing Services
NETGEAR 7000 Series Managed Switch Administration Guide Version 6.0
v1.0, Jan 2007
7-3