Technical Specifications - NETGEAR FSM726NA Installation Manual

Managed Layer 2 Switch with 2 Gigabit Ethernet Ports FSM726 Hardware Installation Guide
Table A-1. Default Configuration Settings (continued)
Features
Port mirroring
Traffic prioritization
ACL
GVRP
GMRP
MAC address aging
SNMP community
VLAN Ingress filtering

Technical Specifications

Table A-2. Technical Specifications
Feature
IEEE network protocol and
standards compatibility
Interface
(Auto Uplink on all RJ-45 ports)
Performance
Address database size
Addressing
10/100/1000 buffer memory
Acoustic noise (ANSI-S10.12)
Heat dissipation
Mean time between failure (MTBF) 562,110 hours (~ 64.2 years)
A-2
Default Setting
Disabled
Disabled
Disabled
Disabled
Disabled
300 seconds
Public (read-only access), private (read/write access)
Enabled
Description
• 802.3 10BASE-T
• 802.3u 100BASE-TX
• 802.3z 1000BASE-SX
• 802.3ab 1000BASE-T
• 802.3x flow control
• 24 RJ-45 connectors for 10BASE-T and 100BASE-TX
• 2 Gigabit Interface converter (SFP) slots for SFP modules
• 2 RJ45 ports for 10BaseT, 100BaseT, and 1000BaseT
• RS-232 console port
• Forwarding modes: store-and-forward
• Bandwidth: 8.8Gbps
• Network latency: Less than 15 microseconds for 64 byte frames in
store and forward mode for 100 Mbps to 100 Mbps transimission
16K media access control (MAC) addresses per system
48-bit MAC address
1-MB embedded memory
36.6 dB
50 BTU/hr.
Factory Default Settings and Technical Specifications
v1.0, July 2009