Page 1
C E R k IWASH CS-18 Integrated Toilet Installation & User Guide THIS PRODUCT WILL NOT FUNCTION IF PROVIDED ANGLE STOP AND SUPPLY LINE ARE NOT USED. THIS PRODUCT WILL NOT FUNCTION IF HOUSEHOLD WATER LINE PRESSURE IS BELOW S0PSI.
l C E R k IMPORTANT SAFETY INSTRUCTIONS When using electronic appliances, especially when children are present, basic safety precautions should always be followed. READ ALL INSTRUCTIONS BEFORE USE DANGER - As with most electronic appliances, electrical parts are live even when the appliance is powered off.
l C E R k SECURITE IMPORTANTES CONSIGNES DE Lors de !'utilisation d'appareils electroniques, en particulier en presence d'enfants, des precautions de securite de base doivent toujours etre respectees. LISEZ TOUTES LES INSTRUCTIONS AVANT UTILISATION DANGER -Comme avec la plupart des appareils electroniques, les pieces electriques sont sous tension meme lorsque l'appareil est hors tension.
Page 5
l C E R k SAFETY PRECAUTIONS For your own safety, follow all precautions in this manual. Caution: In order to avoid hazard due to inadvertent resetting of the thermal cutout, this appliance must not be attached to an external switching device, such as a timer, nor should it be connected to a circuit that is regularly switched on and off by utility.
Page 6
l C E R SAFETY PRECAUTIONS & DANGER ® DO NOT OBSERVE SPRAY WATER STRICTLY Do not get any water or cleaning products on the main unit or power plug. Doing so Always unplug the product from the outlet may cause a fire, electrical shock, heat or a short. before cleaning or maintenance.
Page 7
C E Rk SAFETY PRECAUTIONS & DANGER BEWARE OF LOW-GRADE BURNS. Improper use of a heated seat could cause a low-grade burn. When sitting on the toilet seat for long periods of time, switch the toilet seat temperature to OFF. Always connect the product to the cold water supply.
Page 8
l C E R k SAFETY PRECAUTIONS &CAUTION DO NOT USE THIS PRODUCT OTHER THAN FOR THE PURPOSES LISTED IN THIS MANUAL. PROHIBITED PROHIBITED Do not step on or stand on the toilet seat, lid or main unit. Do not apply strong force or mechanical shock.
Page 9
l C E R k INSTRUCTIONS & GROUNDING GFCI • • GROUNDING This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock. The plug must be plugged into an outlet that is properly installed and grounded.
l C E R k FREQUENCY INTERFERENCE This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
l C E R k INSTALLATION INSTRUCTIONS CAUTION BEFORE INSTALLATION! • Make sure all accessory parts are present. • Do not connect the power until installation is complete. • Ground connection should be done by authorized service person only. 120V only.
Page 12
C E R INSTALLATION INSTRUCTIONS Installation step 1 DO NOT UNPACK THIS UNIT OR DISCARD PACKAGING UNTIL YOU PERFORM THIS STEP! 4.lnstall the cap back. 1.lnstall provided shut off 2.Unscrew the front cap. 3.Remove the mesh filter. valve,close angle valve. 5.Turn on the angle valve switch.Fill the provided test bag from the installed valve.
Page 13
l C E R k INSTALLATION INSTRUCTIONS Installation step 3 2. Lift seat up and unscrew 3.Put the flange sealing ring on braided supply lines and the flange, align the mounting bolts. wires. Important! Make note of where each supply hose attaches. If hoses are reinstalled in the wrong positions, the unit will not work properly.
Page 14
l C E R k INSTALLATION INSTRUCTIONS Before installing the valve, please discharge water from the supply for 1-2 minutes to ensure all debris/ impurities are cleared from the line. 7.Connect the water hose with the angle valve for use. 8.
Page 15
CS-18 FEATURES & REMOTE GUIDE Ensure your seat is plugged in. If the power indicator light on the side panel are on, your seat is ready to use. LED bars instruction: 1st LED bar flashes when you pressing the water/seat /air buttons to adjust the levels ;...
Page 16
CS-18 FEATURES & REMOTE GUIDE • • � USER I USER 2 LIGHT LID COVER SEAT FLUSH OPENICLOSE OPENICLOSE ... . Press quickly to Press quickly Press quickly to raise Press quickly to start...
Page 17
l C E R k CLEANING YOUR iWASH For your safety, make sure the seat is powered OFF AND unplugged before cleaning. CLEANING THE FILTER When the water supply valve is closed, cut off the machine water supply, do the following operation.
C E Rk TROUBLESHOOTING GUIDE ISSUE POSSIBLE CAUSES SOLUTION The seat sensor is covered by cloth Ensure the home's main circuit breaker or any other object. Sensor must be is in the ON position. Also, ensure the activated by skin contact in order for G FCI receptacle hasn't tripped to the most functions of the seat to work.
Page 19
Power off your bidet by unplugging the power plug. • Press and hold the STOP button and LIGHT button on your remote simultaneously for 3 seconds until the indicator lights under the ICERA logo on your remote are on and flashing. •...
PRODUCT SPECIFICATIONS ITEM SPECIFICATION Rated Voltage 110-120V Rated Frequency 60 Hz ° ° Rated Power 1100W (57 F - 61 F inlet water temperature) Water Flow � 7.92 gal/min Water Supply Mode Direct connection to water supply ° ° ° 37.4 F - 104 F (3...
C E Rk WARRANTY INFORMATION 3-YEAR LIMITED WARRANTY For electronic bidet seats and integrated bidet toilet seats, lcera provides a warranty against defects in material and workmanship limited to three (3) years from the date of purchase. Scratching, staining, and other effects from chemical use, water, and atmospheric conditions are not considered manufacturing defects but are consid...
Page 22
lcera USA 16341 Carmenita Road Cerritos, CA 90703 P:855-444-2372 E: service@icerausa.com W: www.icerabath.com CS-18 Manual Printed 10/2024...
Need help?
Do you have a question about the IWASH CS-18 and is the answer not in the manual?
Questions and answers